Vidikron Vision 75, Vision 65 operation manual Information, Setup

Operation

Select Information from the Main Menu to see projector status information: the currently-active source, input signal resolution, aspect ratio, picture memory and lamp usage. This menu also displays the projector serial number.

Should you ever need to contact Vidikron Technical Support, this information will help them answer your questions or resolve product performance issues.

Tip	You can also press INFO on the Vision 65/75 remote control unit (Figure
	2-4)to display this information.

Information
Information
Source	HDMI 1
Resolution	1920x1080
Aspect Ratio	16:9
Picture Memory	ISF Night
Lamp Hours	450
Serial	VIP65VM0735001

To access advanced projector settings, use the up- or down-arrow keys to highlight Setup and press ENTER. Use the number buttons on the remote to enter the Setup menu passcode when prompted and press ENTER again. Then, press MENU on the remote control.

You only need to enter the Setup menu passcode the first time you select

Note that menu after turning on the projector.

Lamp Power: Select Lamp Power from the Setup Menu to adjust the lamp output level. You can choose to run the lamp as bright as possible (200W; this is the default setting) or you can choose the lower (170W) setting. Generally, lower lamp output prolongs the life of the lamp, but decreases brightness.

Lamp Hours: When you replace the projector lamp (refer to Lamp Replacement on

page 63), you should also reset the lamp timer. To do this, select Lamp Hours from the Setup menu. Press the right-arrow key on the remote to highlight “Yes,” then press ENTER to confirm the reset.

Note	Reset the Lamp Timer ONLY after you replace the lamp. Otherwise, the
	reported “Lamp Hours” will be inaccurate.
WARNING	Do not exceed the recommended lamp life of 2000 hours. An old lamp
	becomes increasingly fragile and prone to sudden failure.

Fan Mode: Select Fan Mode from the Setup Menu to control the operation of the projector’s cooling fan.

In most cases, the default Fan Mode (Normal) will maintain the correct operating temperature. If the lamp frequently turns off due to overheating, or in certain high-altitude operating environments, you may need to change this setting to Hi. Altitude or Manual.

To manually set the fan speed, select Manual and press ENTER. Then, use the on-screen slidebar to adjust the speed.

Background Color: Press the or button to select the image Background Color (black, blue or gray). The Background Color appears when no incoming signal is present.

PIP: To enable or disable the picture-in-picture (PIP) feature, highlight PIP in the Setup menu and press or to select On or Off.

Setup

Setup

Lamp Power	200 Watts
Lamp Hours	>
Fan Mode			Normal
Background Color			Black
PIP			Off
VAC		0
12-volt Trigger			Normal
V. Correction			0
Amplitude	>
Auto Off	0
Default

Vidikron Vision Model 65/Model 75 Installation/Operation Manual 57