Vidikron Vision 65, Vision 75 operation manual Whitney Prismatic, Adjustment

Installation

Focus: Finally, rotate the Focus Ring on the anamorphic lens
to fine-tune the optical focus.	S

U

C

O

F

Whitney (Prismatic) ➤	The Whitney (Prismatic) Anamorphic lens mount kit consists of everything shown in Figure
Anamorphic Lens Installation	3-19.Some components shipped with your projector may differ slightly from what is shown
and Adjustment	in these instructions.

1Anamorphic Lens

2Base Plate

3Screw, Phillips M6x16mm (2x) and 1/4” Flat Washer (2x)

(not shown; secures Base Plate to bottom of projector)

6Pitch/Y-Adjustment Screw, Phillips

Pan Head, 4-40 x 3/8” (4x) and Fender Washer (4x)

5Vertical Mounting Bracket (2x)

4Yaw/Z-Adjustment Knob (2x) and Washer (2x)

Figure 3-19. Prismatic Anamorphic Lens Mounting Assembly - Exploded View

1.Use the Pitch/Y-Adjustment Screws and Washers (item #6) to attach the Vertical Mounting Brackets (item #5) to the Anamorphic Lens (item #1).

2.Place the lens with the brackets installed on top of (or under, if the projector is inverted) the Base Plate (item #2), so that the two threaded posts at the bottom of the brackets pass through the corresponding slots on the base plate.

3.Secure the lens assembly to the base plate with the Yaw/Z-Adjustment Knobs and Washers (item #4).

Tip	To avoid clipping the corners of the image, position the anamorphic lens
	as close as possible to the primary lens.

40 Vidikron Vision Model 65/Model 75 Installation/Operation Manual