Operation
•Program Edit: To edit the seven timer programs, press or repeatedly to highlight Program Edit and press the ACTION () button. Then, proceed as follows:
aProgram: Press or to select a program to edit.
bTo define the first command in the
program, press to select “01” and press the ACTION () button.
Weekly Command Timer | 1/8 | ||||
|
|
|
|
|
|
| Program |
|
| 1 |
|
| 01 | 6:30 |
| PON | |
| 02 | 6:30 |
| IMS:SL1A | |
| 03 | 6:35 |
| OMS:SCR1 | |
| 04 |
|
| ||
| 05 |
|
| ||
| 06 |
|
| ||
| 07 |
|
| ||
| 08 |
|
|
RETURN
CHANGE
SELECT
cPress to select “Time.”
dPress or to change the time of day at which you want the CinemaWall to execute the command, in
ePress to select “Command.”
Weekly Command Timer
Program 1
Command No | 01 |
Time6:30
CommandIMS:SL1A
RETURN
CHANGE
SELECT
fPress or to select the command to be executed at the time you set in Step d. Refer to Table
gPress RETURN (RETURN ).
hRepeat Steps b through g for commands 2 through 8 in the program.
iTo define additional commands, press repeatedly to access them in the Program Edit menu. Or, to move between “pages” of the command list (there are eight commands per page), press or .
Repeat this procedure as needed to create additional programs.
Onscreen Display: Select Onscreen Display from the OPTIONS menu and set it to On to enable the display of the following
•Current input and aspect ratio on
•Input switch
•No signal display
•Mute and the remaining time on the
To prevent the display of these items, set Onscreen Display to OFF.
Initial INPUT: Select Initial INPUT from the OPTIONS menu to have the CinemaWall switch to a specific input every time it is turned on. Set it to Off to have the CinemaWall display whichever input was active when it was turned off.
Note | In order to select an initial input, you must set INPUT lock to Off |
(refer to page 49). |
48 | CinemaWall |