Runco XP-65, XP-50 Using Picture-In-Picture PIP, Activating PIP Swapping the Main PIP Images

Operation

Table 4-1. Aspect Ratio Settings (continued)

Aspect Ratio Setting
(Note)		Input Image -> Displayed Image	Description
All Aspect	All Aspect
= ON	= OFF
LETTER-	–		LETTERBOX2 scales
BOX3			(zooms in on) a 2.35:1
			image linearly (by the same
			amount on all sides) to fill a
			16:9 display, cropping the
			image on all sides.
			Select CINEMA to view
			2.35:1 source material in its
			native aspect ratio.
			CINEMA masks the upper
CINEMA	CINEMA		and lower portions of the
			screen to create a viewable
			area with a 2.35:1 aspect
			ratio.
			The geometry of the active
			image area is unchanged.

Note: To make all of the aspect ratio selections listed here available to the viewer, set All Aspect in the OPTIONS menu (described on page 51) to On.

4.7 Using

Picture-In-Picture (PIP)

Activating PIP ➤

Swapping the Main and ➤

PIP Images

Use PIP to display an image from two sources at the same time in a variety of ways.

For more information on setting up PIP and how it works, refer to MULTI PIP SETUP on page 43.

To activate PIP, press the MULTI PIP () remote control button.

Press SWAP () to replace the main image with the secondary sub-image and vice versa.

[Picture and Picture]		[Picture out Picture]		[Picture in Picture]
Main picture	Sub picture	Main picture	Sub picture	Main picture Sub picture

A B

A

B

A

B

B A

B

A

B

A

26 CinemaWall XP-50/XP-65 Installation/Operation Manual