Sanyo PLV-HD2000N Connecting Projector, Terminals of Projector, Replacement of Terminal

CONNECTING PROJECTOR

TERMINALS OF PROJECTOR

This projector applies various input/output terminals and 4 terminal slots for expansion to tune to diversity of signals from computers and video equipment. 4-built-in Terminal Slots enable you to arrange desired combinations of input sources just by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.

3 TERMINAL SLOTS (Factory set)

INPUT/OUTPUT TERMINALS

SERIAL PORT IN		IN	LINK A	OUT
SERIAL PORT OUT		R/Pr	G/Y	B/Pb	H/HV	V
R/C JACK	USB			DVI
AUDIO OUT
R	L
	RESET

(MONO)

IN LINK B OUT

AUDIO	CONTROL PORT
R	L
(MONO)
AUDIO	CONTROL PORT
R	L

(MONO)

INPUT 4 INPUT 3 INPUT 2 INPUT 1

DUAL-LINK SDI Terminal

5 BNC Terminal

DVI Terminal

REPLACEMENT OF TERMINAL

NOTE; When replacement of terminal board, MAIN ON/OFF switch should be OFF position.

1	Remove 2 Screws on terminal.
2	Pull out terminal by holding handle.
3	Replace terminal. Insert terminal along Guide to fit Plug
	into Socket.
4	Tighten screws to secure terminal.

NOTES ON ORDERING OR USING OPTIONAL INTERFACE BOARD

When ordering or using Optional Interface Board (Terminal Board), contact your sales dealer. When con- tacting the sales dealer, tell the Optional Control Number (Op.cont.No.) in the menu that is located under Language Select Menu. (See page 38.)

Screws

Guide

Socket

Plug Figure shows DVI terminal.

12