Sanyo PLV-HD2000N, PLV-HD2000E owner manual Troubleshooting, Problem Try these Solutions

APPENDIX

TROUBLESHOOTING

Before calling your dealer or service center for assistance, check matters below once again.

1.Make sure you have connected a projector to your computer or video equipment as described in section "CONNECTING PROJECTOR" on pages 13 ~ 16.

2.Check cable connection. Verify that all computer, video and power cord are properly connected.

3.Verify that all power is switched on.

4.If a projector still does not produce an image, re-start your computer.

5.If an image still does not appear, unplug a projector from your computer and check your computer monitor's display.Problem may be with your graphics controller rather than with a projector. (When you reconnect a projector, be sure to turn a computer and monitor off before you power up a projector. Power equipment back on in order of : Projector and computer.)

6.If problem still exists, check following chart.

Problem:	Try these Solutions
No power.	● Plug a projector into your AC outlet.
	● Turn MAIN ON/OFF switch to ON.
	● Press POWER ON/OFF switch to ON.
	● Make sure READY Indicator lights.
	● Wait 90 seconds after a projector is turned OFF when turning a projector back on.
	NOTE : After pressing Power ON-OFF button to OFF, make sure a projector works as
	follows:
	1. LAMP indicator lights bright and READY indicator turns off.
	2. After 90 seconds, READY indicator lights green again and a projector may be
	turned on by pressing Power ON-OFF button.
	● Check WARNING TEMP. and READY indicator. If both WARNING TEMP. and READY
	indicator flashes, a projector cannot be turned on.
	(See "TURNING ON/OFF PROJECTOR" section on page 23.)
	● Check Projection Lamp. (Refer to page 44.)
Image is out of	● Adjust focus of a projector.
focus.	● Check Projection Lens to see if it needs cleaning.
	NOTE : Moving a projector from a cool temperature location to a warm temperature location
	may result in moisture condensation on Projection Lens. In such an event, leave a
	projector OFF and wait until condensation disappears.
Picture is Left/Right	● Check Ceiling / Rear feature. (See “SETTING” section on page 39.)
reversed.
Picture is	● Check Ceiling feature. (See “SETTING” section on page 39.)
Top/Bottom
reversed.
Some displays are	● Check Display feature.(See “SETTING” section on page 38.)
not seen during
operation.
No image.	● Check connection between your computer or video equipment and a projector.
	● When turning a projector on, it takes about 20 seconds to display an image.
	● Check system that you select is corresponding with your computer or video equipment.
	● Make sure temperature is not out of Operating Temperature (5°C ~ 30°C).
Remote Control Unit	● Check batteries.
does not work.	● Make sure nothing is between Infrared Remote Receiver and Remote Control Unit.
	● Make sure you are not too far from a projector when using Remote Control Unit.
	Maximum operating range is 16.4’ (5m).
	● Check remote control code from Remote Control Unit.
	(See “SETTING” section on page 40.)

46