BEFORE OPERATION
REMOTE CONTROL CODE CHANGE AND OPERATING RANGE
Code Change
This projector has eight different remote control codes (Code
1 | While pressing the MENU button, press the IMAGE button | |||
| number of times corresponding to each remote control code | |||
| number. Each time you press the IMAGE button, the code is | |||
| changed sequentially. (See the list below.) |
| ||
2 | To initialize the remote control code for the remote control, | |||
| slide the RESET switch to the RESET, and then to the ON. | |||
| The initial code is Code 1. |
|
| |
Remote Control Code | Number of Times of |
|
| |
Pressing IMAGE |
|
| ||
|
| Button |
| |
| Code 1 | 1 | ▲ |
|
| ▲ |
| ||
|
|
| ZOOM |
|
| Code 2 | 2 | FOCUS |
|
|
|
| ▲ |
|
| Code 3 | 3 | ▲ | MENU button |
|
|
| ||
| Code 4 | 4 |
|
|
| Code 5 | 5 |
| SELECT |
|
|
| ||
| Code 6 | 6 |
|
|
| Code 7 | 7 |
|
|
| Code 8 | 8 |
|
|
IMAGE button
RESET
Operating Range
Point Remote Control Unit toward projector (Receiver Window) whenever pressing any button. Maximum operating range for Remote Control Unit is about 16.4’ (5m) and 60° in front and rear of a projector.
60°
16.4’ (5 m)
16.4’ (5 m)
60°
REMOTE CONTROL BATTERIES INSTALLATION
1 | Remove battery |
compartment lid. |
Press lid down- ward and slide it.
2 | Slide batteries into | 3 Replace compartment lid. |
compartment. |
Two AA size batteries
For correct polarity (+ and
terminals are in contact with pins in compartment.
To insure safe operation, please observe following precautions :
●Use (2) AA or R06 type alkaline batteries.
●Replace two batteries at same time.
●Do not use a new battery with an used battery.
●Avoid contact with water or liquid.
●Do not expose Remote Control Unit to moisture, or heat.
●Do not drop Remote Control Unit.
●If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries.
●Danger of explosion if battery is incorrectly replaced.
●Dispose of used batteries according to the batteries manufacturers instructions and local rules.
20