Sanyo PLV-HD2000N, PLV-HD2000E owner manual Fig-9

7	Adjust focus of the Projection Lens. (LNS-W01, LNS-W01Z, LNS-T01, LNS-T01Z and LNS-W03
	only.) Set up the projector and project image on the screen. Loosen Focus Lens Lock Screw and

rotate Projection Lens to obtain proper focus. After adjusting focus, be sure to lock Projection Lens with Focus Lens Lock Screw securely. (See Fig. 4.) Adjust focus of Projection Lens MODEL LNS- W03, following Focus Adjustment on page 6.

8

9

10

Replace Lower Lens Cover. Slide Light-Block Sheets into the guide of Lower Lens Cover and set them in front of the flap. (See Fig. 9.) Fix Lower Lens Cover with 4 Screws C. (See Fig. 2.)

Replace Upper Lens Cover. Slide Light-Block Sheets into the guide of Upper Lens Cover and set them in front of the flap. (See Fig. 9.) Fix Upper Lens Cover with 2 Screws A. (See Fig. 1.)

Turn the projector on and operate Lens shift, Zoom and Focus fully to check Light-Block Sheets. If Light-Block Sheets interfere with those operations, check Light-Block Sheets are set properly.

Slide both upper sides of LIGHT BLOCK

Sheets in between 1 and 2 .

1CABINET

	Slide into front
FLAP	of the flap.

UPPER LENS

COVER

2GUIDE

LIGHT-BLOCK

SHEETS

	FLAP	Slide into front
LOWER LENS		of the flap.
COVER

Fig-9

- 5 -