CONNECTING PROJECTOR
SERIAL PORT
IN TERMINAL
If you control a projector by computer, you must connect a cable (not supplied) from your computer to this terminal.
USB PORT (Series B)
This port is used to service this projector.
Connect USB port of computer to this port.
SERIAL PORT
OUT TERMINAL
This terminal outputs signal from SERIAL PORT IN. More than two projectors can be controlled with one computer by connecting SERIAL PORT IN. of another projector to this terminal.
SERIAL PORT IN
SERIAL PORT OUT
R/C JACK | USB |
|
|
|
|
AUDIO OUT
R 
L
RESET
(MONO)
IN LINK A OUT
R/Pr | G/Y | B/Pb | H/HV | V |
|
| DVI |
|
|
IN LINK B OUT
AUDIO | CONTROL PORT |
R | L |
(MONO) | |
AUDIO | CONTROL PORT |
R | L |
(MONO)
INPUT 4 INPUT 3 INPUT 2 INPUT 1
RESET BUTTON
R/C JACK
When using Wired / Wireless Remote Control Unit as Wired Remote Control, Connect Wired Remote Control Unit to this jack with Remote Control Cable (not supplied).
(Refer to page 19.)
This projector uses a micro processor to control unit. Occasionally, micro processor may malfunction and need to be reset. This can be done by pressing RESET button with a pen, which will shut down and restart unit. Do not use RESET function excessively.
AUDIO OUTPUT JACKS
Connect an external audio amplifier to these jacks.
(Refer to P15, 16.)
14