Sanyo PLV-HD2000N, PLV-HD2000E owner manual Fig-4

4	Remove Lens Cap on the rear (mounting side) of Projection Lens and mount Lens on the lens
	Attachment with 4 Screws. (Use screws attached on lens.)
	Connect the Lens Motor Lead connector to the socket on the right-top of the lens attachment.
	(Motor Driven Lens only.) See Fig. 5.

LENS LOCK	LENS ATTACHMENT
SCREW	LENS LOCK
	LEVER

Fig-4

DRIVER

IN THE LENS

Part No. (610 275 6029)

LOCATE MOTOR

LENSON RIGHT SIDE ATTACHMENT

SOCKET

Lens attachments For each lens.

Lens Model No.		LENS ATTACHMENT
		TYPE No. (PART No.)
LNS-W01, LNS-W01Z, LNS-W02Z,		Lens Attachment 01
LNS-W03, LNS-T01, LNS-T01Z,		POA-LNA-01
LNS-T02, LNS-T03, LNS-S02,	(610 303 8742)
LNS-S02Z, LNS-S03, LNS-M01Z,
LNS-W04, LNS-W06
LNS-W02, LNS-M01		Lens Attachment 02
		POA-LNA-02
		(610 304 6228)

CONNECTOR

LENS MOTOR LEAD

Fig-5

5	Grasp (release lock) the Lens Lock Lever and turn it fully upward. (See Fig. 6.)
	Install the Lens into the projector. Grasp the Lens Lock Lever and turn the Lever fully downward until
	lever is Locked (clicked position) properly. (See Fig. 7.)
	When installing the Motor Driven Lens, be sure to mount Lens Motor on right side. (See Fig. 4.)
	After installing the lens, make sure the Lens is not loose and properly installed.
	LENS LOCK RELEASE	LENS LOCK

Grasp (unlock) Lens Lock Lever and pulling upward.

Grasp (unlock) Lens Lock Lever and fully pulled downward until it is locked (clicked).

Fig-6

Fig-7

- 3 -