Transition Networks
DVP 5140K
manual
Specs
Install
Fault Isolation and Recovery
Maintenance
Reset Button
Testing Fiber Links
Using Status LEDs
Page 34
Page 33
Page 35
Image 34
Page 33
Page 35
Contents
Multichannel Media Converter
Compliance Information
Table of Contents
Operation
AC Power Supply Module/Optional Redundant AC Power
Introduction
Multichannel Media Converter Models
Media Converter Channels
Reset Button
Introduction
Management Module LEDs
Multichannel Media Converter Management Module
Serial Port
Multiport Management Software at Remote
Network RJ-45 Connection
Page
Installation
Connecting Channel Ports to Network
Preparing the Site
Installation
Unpacking METTF10xx, MFETF10xx Equipment
Installing Optional Redundant Power Supply Module
Setting Management Module Jumper
Installing Power Supply Module
Installing Multichannel Media Converter at Site
Standard Rack Installation
Table-Top Installation
Powering the Multichannel Media Converter
Setting FDX/HDX Channel Configuration Switches
Connecting Channel Ports to Network
Setting Full-Duplex/Half-Duplex Configuration Switches
Installing Cable
Installing Fiber-optic Cable
Testing Fiber Links
Installing Twisted-Pair Copper Cable
Norm Test
Setting Network Management Parameters
None
Ethernet Parameters
METTF10xx, MFETF10xx
Installing Multiport Management Software at Remote NMS
TCP/IP
Page
Operation
Management LEDs
Using Status LEDs
Power Supply and Link Test Switch LEDs
Channel LEDs
Using a Terminal Emulator
Operation
Using Terminal Emulator
Operation
Using Multiport Management Software at Remote NMS
Standalone Win32* Systems
Main Power Supply Status is green for OK or red for fail
Page
Maintenance
Fault Isolation and Recovery
Is Multichannel Media Converter Receiving Power?
Are Channel Links Good?
Fault Isolation and Recovery
Hardware Replacement Procedures
Replacing Management Module
Replacing AC Power Supply Module
Technical Specifications
Power
Page
Channel Cable Specifications
Fiber-Optic Cable
METTF1011 -120
MFETF1011
Top
Page
Image
Contents