Agilent Technologies ES, 8753ET quick start Plotter Port

Installing Your Analyzer

STEP 4. Configure the Analyzer

3.Press SET ADDRESSES . Then, depending on your printer/plotter device, choose either PRINTER PORT or PLOTTER PORT . Or, if you are plotting your files to disk, press SET ADDRESSES PLOTTER PORT DISK .

4.Press the key that corresponds to your printer or plotter interface: GPIB , PARALLEL (parallel port), or SERIAL (serial port).

NOTE	The plotter menu is shown as an example. It will only appear if you select
			. Similar interface choices will appear if you select
	PLOTTER PORT
		.
	PRINTER PORT

• If you select GPIB , the GPIB address selection is active. Enter the GPIB address of your printer or plotter,

followed by x1.

• If you have already selected the

PARALLEL [COPY] choice for the parallel-port configuration, you must also select PARALLEL in this menu in order to generate a printed or plotted copy.

1-12 Chapter 1