Changing the unit’s settings
Common procedures
Use the following procedure to change the settings if necessary.
(1)While stopped, press [MENU (SHIFT + SEARCH)] to show the MENU window.
(2)Use [ 
, 
, 
, 
] to select the “SETUP” and press [ENTER].
Menus
The SETUP menu is made up of six
Items
A list of items in the menu you selected.
Options
This shows the current settings. The options are shown when you select an item.
(3)Use [ 
, 
] to select the menu’s tab and press [ 
] or [ 
].
(4)Use [ 
, 
] to select the item you want to change and press [ENTER].
(5)Use [ 
, 
] to select the option and press [ENTER].
•Some options require different operations. Follow the on- screen instructions and the instructions described.
To return to the previous screen
Press [RETURN].
Even if you have changed an option, the change is not accepted unless you press [ENTER].
For your reference:
•If closing the SETUP menu window, the changed settings are accepted.
•The unit retains these settings in its memory until you change them, even if you turn it off.
Summary of settings
Underlined items are the factory presets.
PLAY : Effective items during play.
REC : Effective items during recording
Settings
Clock (see page 15)
You can adjust the clock.
Repeat Duration
Decide the length of the repeated section when you start instant repeat.
[1sec] [2sec] [3sec] [4sec] [5sec] [10sec] [20sec] [30sec] Shipping Condition (see page 15)
The all settings in the SETUP screen return to the factory settings. (except for the TV screen and clock settings (time, date, time zone))
[Yes] [No]
Remote
PAUSE REMOTE
Decide the method of control through the PAUSE REMOTE jack.
[Low Edge] [High Edge] [Low Level]
Low Edge:
Use down edge signals to control recording start and pause.
High Edge:
Use rising edge signals to control recording start and pause.
Low Level:
Recording occurs when the signal is low. Recording is paused when the signal is high.
Baud Rate
Decide the baud rate when using the
Bit Length
Decide the bit length when using the
Stop Bit
Decide the stop bit when using the
Parity
Decide the parity check when using the
Protocol
Decide the protocol when using the
DVD:
The standard
VTR1:
Protocol with high compatibility with
VTR2:
Protocol with high compatibility with equipment manufactured by other companies.
For your reference:
•The operation of this unit may depend on the selected protocol.
– 33 –