[23] 
Stop
In VCR, DVD or CD mode: This button works the same way as in your original remotes.
IN TV mode: Coloured key (Green), control of videotext or special equipment functions.
[24] 
REC (record )
This key works the same way as the one on your original remote for your VCR. In order to avoid a mistake you have to press this key twice to activate this feature.
[25] 
Pause
In VCR, DVD or CD mode: This button works the same way as in your original remotes.
IN TV mode: Coloured key (Magenta), control of videotext or special equipment functions.
4.2. Programming the TV, VCR , DVD, SAT and AUX modes
Note: you can dedicate any appliance (TV, DVD, SAT...) to the VCR, DVD, SAT,or AUX
keys: you just need to enter the 3 digit code (found in the code book) of the appliance, i.e. a VCR code under the SAT key. In any case, follow the steps below:
1.Make sure your equipment is switched on (for example TV).
2.Press and hold the SETUP (4) key until the LED indicator lights continuously. Release the SETUP key.
3.Press and release the mode key (3) of the device you want to control (for example TV).
4.Enter the 3 digit code from the Code Book by using the key pad (11). The LED (2) turns off after the last digit is entered. If you entered a wrong code the LED blinks for 3 seconds and then goes off. You have to repeat from step 2.
5.Point the remote in the direction of your TV and press the POWER button (1). Your device should turn off. Check other functions (for example for a VCR FF or REW, etc.). If certain functions are not responding, this indicates that the entered code is not the correct one. In that case repeat the above procedure with the next corresponding code of your brand.
6.Repeat this procedure from step 1 for the other equipment you want to control (VCR, DVD, SAT).
4.3. Manual code search
If your equipment (TV, SAT etc....) does not respond, try the other codes for your brand. If
it still doesn’t respond, try the manual code search method.
Note: as you can dedicate any appliance (TV, DVD, SAT...) to the VCR, DVD, SAT or AUX keys, you first need to enter any 3 digit code for the kind of appliance you wish to control (found in the code book), i.e.: If you want to program a SAT under the AUX key, enter ANY SAT code found in the code book and then follow the steps below
1.Make sure your equipment is switched on.
2.Press and hold SETUP (4) until the LED indicator lights steadily. Release SETUP
3.Press the mode key (3) that matches the equipment you want to control (for example TV).
4.Press Channel+ (9) repeatedly until the channel changes.
If you step past the correct code use Channel- (9) to go back to the right code.
5.When the equipment you want to control reacts press
Note: If your equipment doesn't have Channel+ you can use PLAY (VCR or DVD) (22) or POWER (1) key.
10 | MARMITEK |