Watching DVB broadcasts
Conditional Access Module (CI Module)
In order to receive coded digital stations, a Conditional Access Module (CI Module) and a CA Card must be inserted in the CI slot of your TV set. (Page 6)
The CI Module and the CA Card are not supplied accessories. They are usually available from your dealer.
Inserting the CA Card into the CI Module
1Make sure the TV set is switched off with the main power switch (a) on the set, or pull the AC plug.
With the side with the gold coloured contact chip facing the side of the CI Module marked with the provider’s logo, push the CA Card into the CI Module as far as it will go. Note the direction of the arrow printed on the CA Card.
Inserting the CI Module in the CI slot
2Remove the rear terminal cover.
3Remove the CI slot cover.
4Carefully insert the CI Module in CI slot 1 or CI slot 2 with the contact side
forward.
The logo on the CI Module must be facing outward,
from the rear of the TV. Do not use excessive force.
Make sure the module is not bent in the process.
If the CI Module is correctly installed, the eject button protrudes a little further.
Switching on the TV set
After powering on with the new CI Module inserted, a dialogue will appear. You must conduct a station search.
5Press OK to start the station wizard.
6Check the recommended search routine parameters and then start the search.
7Replace the cover.
Checking CI Module information
NOTE
•Make sure that CI Module is properly inserted.
•This menu is only available for digital stations.
1Press MENU and the TV menu screen displays.
2Press c/d to select “Setup”, and then press b to move down.
3Press a/b to select “Miscellaneous”, and then press b to move down.
4Press c/d to select the CI Module you want to check, and then press OK.
•The content of this menu depends on the provider of the CI Module.
Removing the CI Module
• Switch off the TV set’s main power switch (a).
1Remove the cover from the rear of
the set.
2Press in the eject button on the
appropriate module slot, and the module will release.
3Remove the module from the set.
4 Replace the cover.
28