Sharp LC-52HD1E, LC-46HD1E Navigating the Digital recorder menu, Items Description Defaults

HDD Digital Recorder operation

Navigating the Digital recorder menu

You can use the Digital Recorder with the default values set at the factory.

This section explains how to customise these values to meet your own preference. To change the settings, first call the Digital Recorder menu screen as explained below.

1Press RED to display the DR archive menu.

DR archive	free capacity 48:42 hrs
SHARP Demo

2While in the DR archive menu screen, press MENU to display the Digital Recorder menu screen.

Digital Recorder menu

DR continuous operation	on off
Recording quality	high
Inform about hidden sections	yes
Jump distance	02
Smart jump	yes
Serial recording tolerance	+-30
Record subtitles	Yes, DVB subtitles preferred

3Press a/b to select the desired item.

4Press c/d to select the desired parameter or enter value with 0 - 9.

Items	Description	Defaults
	If DR continuous operation
DR continuous	is switched on, recording is	on
operation	continuous to permit time-shift
	viewing.
	Adjust the recording quality
	for recording analogue
Recording quality	programmes. This results in	high
	a change in the recording
	capacity.
	If a section has been hidden in
Inform about hidden	an existing archive recording
	you can choose whether to be	yes
sections	advised of this by a message
	or not.
	For time-shift viewing and for
	playing archive recordings
	you can set a jump distance
	(in minutes), so that you can
	jump forwards or backwards
Jump distance	in the programmes by	yes, 02 min
	pushing the buttons Gor
	Jbriefly. Enter the time
	with the numeric buttons on
	the remote control (always
	enter two digits for 01 to 15
	minutes).

Items	Description	Defaults
	By using the Smart jump
	function, you can quickly and
	easily find a certain point in
	the recording (a time shift or
	in the archive). Every time the
Smart jump	direction is reversed when	yes
	jumping using the buttons
	Gor J, the jump
	distance is cut in half. Refer
	to the next page for more
	information on this application.
	To avoid recording a serial
	episode more than once when
	it is shown several times a
	day, a tolerance time must be
	entered.
Serial recording	The serial is then only	± 30 min
tolerance	recorded when it starts
	within the start time ± serial
	recording tolerance. Enter the
	time with 0 - 9 on the remote
	control (always enter two
	digits for 01 to 60 minutes).
	If DVB or teletext subtitles
	are to be recorded with DVB
Record subtitles	programmes, select the	no
	priority for subtitles to be
	recorded here.

Setting pre-record time and post record time

You can set a pre-record and post record time for timer recordings made without VPS. This reduces the risk of parts of the programme not being recorded because it starts earlier and/or finishes later.

NOTE

•Note that this operation is performed via the TV menu, not via the Digital Recorder menu.

1In the TV mode, press MENU to display the TV menu.

2Select “Recording” with c/d and press b to move down.

TV menu
Recording	Connections	Setup	Εxtended function
Recording wizard
Timer list
Pre-record time	00 min
Post-record time	05 min

3Select “Pre-record time” or “Post-record time” with a/b.

4Enter the time with 0 - 9 on the remote control (always enter two digits for 01 to 15 minutes for the pre-record time, and for the Post-record time 00 to 60 minutes).

44