Sharp LC-52HD1E, LC-46HD1E operation manual Timer recording with external, Devices

Menu operation
EManual
		Timer recording with external
You may enter the necessary information for recording
		devices
manually.
1 Select “Manual” instead of “Via EPG” in step 4	ERecorder with AV Link
in Via EPG.	If you use an externally connected recorder with AV
• The station selection screen displays.
	Link or a similar system, the TV set and connected
• You may be routed to the “Time and date” entry
screen if the TV does not recognise the current time.	recorder exchange its own station/timer data.
2 Press a/b/c/d to select the station you want	Please consult the operating manual of your recorder
	to find out if your recorder is AV Link compatible.
to record from, and then press OK.
	In addition use only Euro SCART cables for the
3 Timer list screen appears, outlining each setting
	connection between the TV set and recorder.
used for the upcoming recording. Set the	Analogue stations
following settings as necessary. Confirm with
	The timer data is transmitted automatically from the TV
OK.
	set to the recorder after programming is complete.
1 Recorder: Selection of the recording device.
	The recording is then controlled by the recorder
2 Date: Date of recording
	and the recorder tuner is used for reception of the
3 Recording time: Time of recording
	programme.
4 VPS: Selection of using VPS signal
	The recording data is not saved in the timer list of the
5 Recording type: Selection of recording frequency
(once only, Mon-Fri, daily, weekly or serial [if EPG	TV set. Consequently if you want to change or delete
data is available]).	the timer data then you must do so on the recorder.
• A message appears if there is a conflict between two	Digital stations
programmes. Follow the screen prompts and choose
	If you want to record digital stations with an externally
the one that has priority.
NOTE	connected recorder, then the DVB tuner is used and
	the TV device takes over control of the recorder. Then
• If you use an external recorder without AV Link, you have to	the station on the TV set is locked during the timer
select the recording source in the recorder (e.g. AUX, refer	recording.
to your recorder’s operation manual). In case of recording	ERecorder without AV Link
DVB programmes, the TV’s tuner is used, not the VCR’s
tuner.	If you cannot programme your externally connected
• If you use an external recorder with AV Link, this recording
	recorder from the TV set, but it supports AV Link, the
source selection is controlled automatically.
	receiver of the TV set is always used.
	AV Link must be switched on on the recorder. Read the
Timer list
	operating instructions of your recorder.
Here you will find a list of channels already	In addition use only Euro SCART cables for the
programmed for recording. From here, you can	connection between the TV set and recorder.
also change the recording data (GREEN), delete	Analogue and digital stations
programmed recordings completely (YELLOW), or	You can control the recording from the TV set. The
programme a new recording (RED) by pressing the	recorder must be set manually to the AV input to which
assigned colour buttons.	the TV is connected. Then the station on the TV set is
	locked during the timer recording.

Pre- and post record time

If you record a programme without VPS, you can specify a time span by which your programme time should be brought forward/prolonged so that programmes which begin/end too early/late are recorded from start to finish.

Copy protection

Copy-protected programs will not be output on the EURO SCART sockets for legal reasons.

34