
SETTING TV
TV FUNCTIONS
INTRODUCTION
5INITIAL SETTINGS
This section will guide you through your TV’s initial set up which includes selecting a language for your
1After making all the necessary connections, turn on your TV.
2Press [POWER] to display the Initial Setup menu.
•This operation may take a few moments.
•If Initial Setup menu does not appear, press and hold [ENTER] for 3 seconds, initial setup will appear then proceed to step 3.
If initial set up has already been completed, refer to “LANGUAGE SELECTION” on page 16.
3When you first turn on your TV, the following screen is displayed. Use [K/L] to select the
| InitialI i i l Setup |
|
| |
|
| Select the language for setup display. |
|
|
or |
|
| English | |
|
|
| Español | |
| Elija idioma de preparación. |
| ||
|
|
|
NOTE:
•The initial Autoscan function can be executed for either “Air” or “Cable” only once. When you change the connection (Air/ Cable), set the “Autoscan” again. (Refer to page 14.)
•If you connect to the cable system directly, contact the CATV installer.
•When the scanning is not complete, Helpful Hint will be dis- played every time you turn on the power. If you have previ- ously registered channels when this screen appears, you can access them with [the Number buttons].
No channel is registered.
Press and hold "ENTER" key for 3 seconds.
Contact support hotline provided on manual or back of unit.
Sin canal registrado.
Mantenga oprimida la tecla "ENTER" durante 3 segundos.
Llame teléfono de apoyo en manual o atrás de TV.
Pas de chaîne consign.
Maintenir la touche "ENTER" pressée 3 secondes.
Contacter numero d'urgence dans manuel ou arrière appareil.
•Toll free customer support line can be found on the cover of this manual.
PREPARATION SETTING TV OPERATING TV OPERATING
Sélectionner langue écran config. | Français | |
Select | ENTER Enter | SETUP |
Exit |
•The Antenna Confirmation menu on step 4 will be displayed in the selected language after you press [ENTER].
4Use [K/L] to select source of ANT. IN jack, then press [ENTER].
| InitialI i i l Setup |
|
|
|
or | Make sure the antenna is connected to "ANT IN" jack. | Air | ||
Select the destination of "ANT IN" jack. |
| Cable | ||
|
|
|
| |
| Air |
|
|
|
| Cable | Or |
|
|
|
| ANT IN |
|
|
| Select | BACK | Back | SETUP |
| ENTER Enter | Exit |
5Autoscan will start automatically.
InitialI i i l Setup
Now the system is scanning for channels,please wait.
5%
Analog channels | 1ch |
|
|
|
|
|
|
|
| ||
Digital channels | 0ch |
|
|
|
|
|
|
| SETUP |
Exit
•When scanning has completed, the lowest memorized channel will be displayed.
DVD SETTING DVD TROUBLESHOOTING INFORMATION ESPAÑOL
13
EN