Sylvania 6626LDG owner manual Precautions, Laser Safety, Important Copyright Information

Page 3

15.POWER LINES - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light of power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

16.OVERLOADING - Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

17.OBJECT AND LIQUID ENTRY - Never push objects of any kind into this TV through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the TV.

18.SERVICING - Do not attempt to service this TV yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

19.DAMAGE REQUIRING SERVICE - Unplug this TV from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power supply cord or plug is damaged or frayed.

b.If liquid has been spilled, or objects have fallen into the TV.

c.If the TV has been exposed to rain or water.

d.If the TV does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the TV to its normal operation.

e.If the TV has been dropped or damaged in any way.

f.When the TV exhibits a distinct change in performance, this indicates a need for service.

20.REPLACEMENT PARTS - When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, injury to persons or other hazards.

21.SAFETY CHECK - Upon completion of any service or repairs to this TV, ask the service technician to perform routine safety checks to determine that the TV is in proper operating condition.

22.HEAT - This TV product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (includ- ing amplifiers) that produce heat.

INTRODUCTION PREPARATION SETTING

5PRECAUTIONS

LAMP IN LCD CONTAINS MERCURY, DISPOSE ACCORDING TO LOCAL, STATE OR FEDERAL LAW.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the owner’s manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

RADIO-TV INTERFERENCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruc- tions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encour- aged to try to correct the interference by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Note to CATV system installer:

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the build- ing as close to the point of cable entry as practical.

LASER SAFETY

This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.

CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

CAUTION: VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED. DO NOT STARE INTO BEAM.

LOCATION: INSIDE, NEAR THE DECK MECHANISM.

IMPORTANT COPYRIGHT INFORMATION

Unauthorized copying, broadcasting, public performance and lending of discs are prohibited.

This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual prop- erty rights. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.

TV OPERATING TV OPERATING DVD SETTING DVD TROUBLESHOOTING INFORMATION ESPAÑOL

3

EN

Image 3
Contents 6626LDG a 6626LDG Important note is located on the rear of the cabinet IntroductionPrecautions Laser SafetyImportant Copyright Information To Avoid the Hazards of Electrical Shock and Fire 5SUPPLIED Accessories5SYMBOLS Used in this Manual LocationContents Chip FeaturesDVD DTV/TV/CATV5INSTALLING the Batteries 5REMOTE Control Function5REAR Panel 5CONTROL PanelConnection to Cable BOX or Satellite BOX PreparationConnection Antenna Cable ConnectionHdmi 5CONNECTING Other DevicesVideo Cable Connection Component Cable ConnectionVideo Connection Digital Audio Output ConnectionAnalog Audio Output Connection Autoscan will start automatically Setting TV5INITIAL Settings TV FunctionsPress Setup to display the setup screen AutoscanScanning and memorizing the channels automatically starts 5MANUAL Register 5CHANNEL ListUse K/L to select Antenna, then press Enter Displays signal strength for each channel5ANTENNA Confirmation 5LANGUAGE SelectionMute 5VOLUME AdjustmentOperating TV 5CHANNEL SelectionMono 5SELECTING Audio ChannelsStereo SAPBroadcast station Program guide max lines displayed Effective scanning lines and scan modeTV/DTV channel As the Program guide is displayed5CHANGING the Screen Display Mode 5SLEEP Timer Setup ScreenPress Setup Sharpness 5PICTURE AdjustmentEnergy saving settings ColorCC3 and Text3 Caption Mode CC1 and Text15CLOSED Caption EnterOff Service 1 to ServiceBack Color Font StyleFont Size Font OpacityGeneral Audience 5VCHIPSelection Rating Category Explanations PG-13 GuardianTV-Y TV-MATV-PG TV-GUse K/L to select New Password, then press Confirm password5HDMI Audio Any other discs without compatibility indications Operating DVDDVD Functions 5PLAYABLE Media 5UNPLAYABLE MediaJpeg on Playback5DVD Menu Resume5ZOOM Press Play B, then press Disc Menu When selecting the folder5MP3, Jpeg Playback 5DUAL PlaybackSmall 5TRANSITION Mode5FOLDER Playback Normal5SEARCH Functions Press Search Mode once to display the Chapter Search display5REPEAT Playback OFFALL 5REPEAT AB Playback 5RANDOM PlaybackLater Current playback status 5ONSCREEN DisplayFRE 5SPECIAL SettingsNo subtitles ENGUntil Appears Press Audio repeatedly until the desired sound mode appearsDuring playback, press Search Mode repeatedly To exit the Marker setup displayAudio *1, *2 Setting DVD5DVD Language Setting You can change the output language of the DVD player5DVD Audio Setting Control Levels 5PARENTAL SettingUse s / B to select Use K/L to select the Parental LEVEL, then press EnterUse s / B to select , then press Enter Angle ICONDefault onOthers You can change the other functions5RESET to the Default Setting 5LANGUAGE Code List5TROUBLESHOOTING Guide TroubleshootingChanges automatically Check the batteries of the remote controlRefer to IR Signal Check on Entered channel number5CABLE Channel Designations MaintenanceInformation Glossary5GENERAL Specifications 5ELECTRICAL Specification5OTHER Specifications Español Español 5FUNCIONES DEL Mando a Distancia5INSTALACIÓN DE LAS Pilas 5PANEL Trasero 5PANEL DE ControlConexión Conexión DE Cable DE AntenaConexión CON Caja DE CONVERTIDOR/CAJA DE Satélite 5CONEXIÓN DE Otros Dispositivos Conexión DE Cable DE S-VÍDEO Conexión DE Cable DE ComponentesConexión DE Vídeo Conexión DE Salida DE Audio DigitalConexión DE Salida DE Audio Analógica 5PREAJUSTES Inicial English / Español / FrançaisAutoscan se iniciará automáticamente 5LISTA DE Canales 5PREA. Auto CAUtilice K/L para seleccionar su idioma, y presione 5REGISTRO Manual 5SELECCIÓN DE IdiomaFrancés TransmisiónJpeg en página Reproducción5MENÚ DVD ReanudaciónVos en esta unidad Cuando seleccione la carpetaPresione Disc Menu o BACK/RETURN para volver Limited Warranty
Related manuals
Manual 2 pages 29.08 Kb