Sylvania 6900DTD owner manual Precautions

Page 5

PRECAUTIONS

LOCATION

For safe operation and satisfactory performance of your this product, keep the following in mind when selecting a place for its installation:

Shield it from direct sunlight and keep it away from sources of intense heat.

Avoid dusty or humid places.

Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes at the top and bottom of the unit. Do not place the unit on a carpet because this will block the ventila- tion holes.

Install unit in a horizontal position.

Avoid locations subject to strong vibration.

Do not place this product near strong magnetic fields.

Avoid moving this product to locations where tem- perature differences are extreme.

AVOID THE HAZARDS OF

ELECTRICAL SHOCK AND FIRE

Do not handle the power cord with wet hands.

Do not pull on the power cord when disconnecting it from an AC wall outlet. Grasp it by the plug.

If, by accident, water is spilled on your unit, unplug the power cord immediately and take the unit to our Authorized Service Center for servicing.

Do not put your fingers or objects into this product cassette holder.

Do not place anything directly on top of the unit.

IMPORTANT COPYRIGHT INFORMATION

Unauthorized recording or use of broadcast televi- sion programming, video tape, film or other copy- righted material may violate applicable copyright laws. We assume no responsibility for the unautho- rized duplication, use, or other acts which infringe upon the rights of copyright owners.

FCC WARNING- This equipment may gener- ate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction man- ual. The user could lose the authority to oper- ate this equipment if an unauthorized change or modification is made.

This equipment has been tested and found to com- ply with the limits for a Class B digital device, pur- suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be deter- mined by turning the equipment off and on, the user is encouraged to try to correct the interfer- ence by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a cir- cuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

1 Before Using

The serial number of this product may be found on the back of the unit. No others has the same serial number as yours. You should record the number and other vital information here and retain this book as a permanent record of your purchase to aid identification in case of theft. Serial numbers are not kept on file.

Date of Purchase

Dealer Purchase from

Dealer Address

Dealer Phone No.

Model No.

Serial No.

5

EN

1A23

Image 5
Contents 6900DTD Table of Contents Important Safeguards S2 8 9 8 a Precautions Atsc and Ntsc Information on digital broadcastingReceives both Atsc Major features of STBHdtv NtscPower indicator Power buttonRemote control sensor Setup buttonRear Panel Remote Control Installing batteries AccessoriesSnap the battery cover back Remote controller unit and AA batteries x2 Part No. NE120UDSetup Wizard Reference to Setup menuDisplay ChannelClock Detail Cable BOX When Connecting to Cable BOX AlsoConnections to antenna Right Connections to other devices Connections Connections STB connection using S-VIDEO output to Sdtv Connections STB connection using Video output to Sdtv Stereo Component Connections STB connection to a standard stereo systemDigital Decoder Connections STB connection to a decoder with Dolby DigitalVCR Setup Wizard 1/8 will appear Initial setupSetup Wizard will appear Buttons, then press Enter Setup Wizard 3/8 will appearSTB starts scanning channels To skip the scanningRefer to Information on Time Zones on Setup Wizard 5/8 will appearSelect OFF on the channel map, then press Enter Press Enter when the cursor is on SETWhen not using the auto-clock setting Press Enter 26-1Selecting a desired channel When using CH o/p buttonsWatching TV TV-Y When using number buttons E.g., entering 26-11800 1830 1900 1930 2000 Channel banner When tuning in a channel from NtscPress Info to display a channel banner Press Info to clearLock DTVChoosing audio Language Audio map Only when tuning in AtscSequence will repeat as shown below when available When tuning in NtscWhen tuning in Atsc Press Audio buttonPress Still o button while watching Picture StillPress any button to quit During STILL, the programs audio will continueOn screen messages No SignalScanning Restricted ProgramEPG will appear on the screen Press EPG button while watching TVWhen selecting a program being broadcast Select the desired program using o / p Navigation buttonsWhen going back to the previous CC Closed Caption Components of Electronic Program Guide EPGSetup menu for preference When adding the digital channel Press Setup to display Setup menuAdding channels ADD/ DeleteButtons, then press Enter Number Select Channel using o / p navigationTo add, first enter the digital channel Channel menu will appearPress Setup to exit Setup menu Select ADD using o / p navigation buttons, then press EnterInformation on Channel Map To continue addingYou can add and delete channels in the channel map Deleting channelsDelete To delete the digital channelCursor will move to the channel map Will be indicated in the box at the top of the screen Press Enter when the cursor is on the digital channelDigital channel number 26 will be deleted To continue deletingWhen adjusting the digital channel Adjusting antennaAntenna Channel 26-1 will be tunedReceiving the signal strength of the channel Adjust the antenna direction to get the best receptionWhen adjusting other channels continuously Antenna menu will appear, then STB startsAutoscan Receiving channelsSelect Next using s / B navigation buttons, then press Enter When no Signal appears on the screen To cancel Autoscan during scanningAutoscan is complete Verify the antenna connection, then completeDisplay menu will appear Selecting screen formatsScreen Ratio Screen ratio options will appear Press Enter to exit Setup menuScreen ratio should be selected to fit your TV screen Screen ratio will be setDisplay Mode Information on 43 TV Display mode will be setSTB 43 TVZoom Letter BoxFull SidebarClock menu will appear Setting the clockTime Zone setting menu will appear Daylight savings time setting menu will appearHawaii AlaskaPacific MountainCurrent time setting menu will appear Activated Your settings will be activated4,5,6 Channel search completed. will be indicated Will become black on the channel mapSelect OFF from the channel-map, then press Enter Detail menu will appear Setting a new passwordChip / CC Quit Channel Display Clock Detail CHIP/CC menu will appear Password setting menu will appearYour new password is stored CHIP/CC Setting for V-CHIP/CCCHIP/CC password window will appear When choosing TVcontrols V-CHIP Ratings Enter your 4-digit passwordWhen choosing STBcontrols V-CHIP Ratings Press Setup to exit Setup menu Mpaa Rating Setting Mpaa ratingPress Setup to display Setup menu Mpaa rating setting menu will appear When you want to block all PG-13 movies TV Rating Setting TV ratingPress Setup to display Setup menu Information on TV ratings TV rating setting menu will appearQuit Channel CC Selection Selecting CC optionsEnter your 4-digit password Selected CC option will be set CC options menu will appearServe as the preferred data channels Menu Language Choosing the screen languageLanguage menu will appear Then press EnterTroubleshooting Audio problems when Symptom RemedyUsing coaxial digital With weak signalGlossary and Acronyms SpecificationsMpaa DSTNota Ubicación de los controlesInstalación de las pilas AL Conectar EL Equipo a UNA Caja Para Cable Conexiones de antenaConexión del STB a un Sdtv utilizando la salida Video Configuración inicial Cuando el cursor se encuentre en SET, presione Enter NuméricosPresione Enter Si no desea usar la función de ajuste automático de relojLimited Warranty