
3. Remote control unit
c)Press the F1 key: the LED blinks once.
d)Enter the desired code (see the code list) with the numeric keys. If this code is accepted, the LED again blinks twi- ce. If the code does not exist in the table, the LED lights for about two seconds.
1.4 Station search
Follow the instructions for programming the code for VCR, DVD, CD, tuner, tape as far as the step where the code num- ber is entered. Then enter the
Release the "Station search" key and press the "Select" key to confirm that you want to execute a station search (the code which was found is saved).
After completion of the station search, or when all code numbers have been inter- rogated, the corresponding LED blinks five times.
2.Determining which code is already programmed (read- out mode)
☞When you select the steps a)...e) ,you have about 15 seconds to continue with the next step. If you do not do so within this time, the unit automatically returns to the TV level.
a) In order to determine which code is
programmed for a level, first select the level as described in section 1.1, steps a) and b).
b) Enter | on the numeric keys. The | |
LED blinks twice to acknowledge your | ||
input. |
|
|
c) Press numeric key | (for the first digit | |
of the code). The LED now blinks the | ||
number of times corresponding to the | ||
programmed digit (if, for example, the | ||
LED blinks three times, the digit 3 is | ||
programmed). |
| |
d) Press numeric key | (for the second | |
digit of the code). The LED now blinks | ||
the number of times corresponding to | ||
the programmed digit (if, for exam- | ||
ple, the LED does not blink, the digit 0 | ||
is programmed). |
| |
e) Press numeric key | (for the third |
digit of the code). The LED now blinks the number of times corresponding to the programmed digit (if, for example, the LED blinks seven times, the digit 7 is programmed).
In this example, the currently programm- ed code is thus
If you lose count while reading out the code, simply start again at step 2c).
9