Panasonic AJ-D455P operating instructions Reproducing the time code/user bit

Reproducing the time code/user bit

1

2

Place the unit in the stop mode.

Press the CTL/TC/UB/REMAIN button until TC or UB is selected.

TC: The time code is displayed.

UB: The user bit is displayed.

•When it is no longer possible to read the time code, it is interpolated using the CTL signal.

3

Press the PLAY button.

Playback now commences, and the time code appears on the display.

If the SUPER ON/OFF switch is at ON, the time code value is superimposed onto the video signals which are output from the VIDEO OUT 3 or SERIAL OUT 3* connector.

*The superimposing takes effect only when the AJ-YA455P serial interface board (optional accessory) is used.

<Notes>

•The colon between the seconds and frames changes to a period when the drop frame time code is read.

•When the time code signal cannot be read, the time code is automatically interpolated by the CTL signal.

The front panel counter display appears as shown below.

T R 00:01:04:07

The colon between the seconds and frames changes to a period during drop frame mode.

This flashes when the time code signal is missing.

40