Panasonic VQT0C55 manual Setting time codes, Time code recording, Preset time codes

RECORDING – Setting time codes –

Time code recording

This unit has a built-in time code reader/ generator. During recording, time codes are re- corded. During recording of data from the built-in time code generator , the user-bits are not recorded.

According to the recording conditions, time codes are recorded as follows:

Time codes are recorded in the REC RUN mode. (REC RUN: time codes advance only during recording.)

Condition	Time code recording
Time code is preset with this unit.	• Time codes preset in the built-in time code generator are re-
	corded. (First time only)
	• When recording ends, the set time codes becomes void and
	regeneration occurs.

		Memo
			mode is selected from the NDF/DF item of the TIME
	The framing
	CODE menu. (NTSC only)
Time code is not preset.	• It reads the time codes recorded on the tape and continues
	recording time codes from these values. (Regeneration)
	• If no time code is recorded, it starts from “00”.
	* Sometimes, the time codes recorded at the beginning of the
	tape may not be read.

Preset time codes

button

		VCR		POWER
	DISPLAY			SET button
	BARS	STILL	BLANK	/I
		MODE
MENU				AUDIO
	MENU	SEARCH+		MUTING
button
button				OUT SEL.
		SET		button
		SEARCH–		OUT LEV.

button

			PLAY button
			EJECT
			EJECT button
			MENU
UB		REC	PLAY PAUSE
	DVCAM NTSC PAL REC INH.		PAUSE button
	1 / 3		SET
PUT	CH	REW	FF
NE	2 / 4		STOP
	AUDIO		FF button
S-VIDEO
	REW button		STOP button

Memo

When the REC button is held down in the STOP mode, the value of the built-in time code generator is displayed.

Time codes are preset via the TIME CODE menu. It can be set via either the remote controller or the Main unit.

⬛Press the POWER button on the Main unit or the re- mote controller to turn on the power and set the unit to the STOP mode.

*To set it with the main unit, first remove the cassette from the unit if it is loaded.

E-35