Panasonic VQT0C55 manual Precautions on the use of cleaning tape, Cassette tape, Memo

Page 8

INTRODUCTION

Precautions on the use of cleaning tape

Please use cleaning tape produced by PANASONIC.

Please follow the instructions below when using the cleaning tape.

1. The tape will run for 10 seconds in the PLAY mode. (Thereafter, it stops automatically and enters the STOP mode.)

After loading the cleaning tape, press the PLAY button.

2.For a single cleaning session, use it up to 3 times.

3.Please refer to the following table as a guide for cleaning.

Memo:

1.Under low humidity conditions, (10% RH to 30% RH), please perform head cleaning at intervals of half of the following stated periods.

2.If DVM83 is used immediately after cleaning, the VTR warning (“HEAD CLEANING REQUIRED!”) may disappear only after the tape has run for some time.

3.Please use the cleaning tape at room tempera- ture (10˚C to 35˚C).

4.Instructions for using the cleaning tape are stated inside its case. The contents may be slightly dif- ferent from those stated here.

Please follow the instructions in this manual.

Operating environment

Low temperature

Room temperature

of the unit

5˚C to 10˚C

10˚C to 35˚C

 

 

 

Guide for using

1 to 2 times every

1 to 2 times every

cleaning tape

5 hours

20 to 30 hours

 

 

 

Cassette tape

This unit can record onto and playback standard DV and mini DV cassette tapes (for SP mode only). Please use the following PANASONIC cassettes

with the or the

logos.

 

Standard DV cassettes

Mini DV cassettes

AY-DV276

 

AY-DVM63

AY-DV186

 

AY-DVM33

AY-DV124

 

 

Memo

DVCAM cassettes can be recorded in DV for- mat.

Tapes recorded in DVCAM format can be played (SP Mode).

DVM83 cassettes(Mini DV 83min tape) can- not be used with this unit.

Erasure prevention

DV cassettes have a safety slide at the back to prevent accidental erasure.

To prevent accidental erasure of important records, push the slide to the “SAVE” position.

To record, push the slide to the “REC” posi- tion.

Slide

REC

SAVE

Precautions on the use of tape

Reverse sides of videotapes cannot be used.

Please store the tape only after it has been fully rewound, so as to avoid damaging the tape.

Please store the cassette in places low in humidity, well-ventilated and fungus-proof.

When a cassette is used repeatedly, noise may increase due to e.g., dropout, etc. hence affecting its performance. Please do not use dirty or damaged tapes as they will shorten the life span of the rotation head.

E-8

Image 8
Contents Digital Video Cassette Recorder VQT0C55Supplement Port Cable LengthFor Your Safety Please Read the Following Text Carefully For Continental EUROPE, ETCWireless remote control DV formatHigh picture and sound quality by digital tech- nology Compatible mechanisms for standard/mini DV cassettesTable of Contents Precautions Introduction Place of storage and use  Handling the unitDaily maintenance and regular inspection  Regular inspection maintenance Head cleaning Maintenance consultationPrecautions on the use of cleaning tape Precautions on the use of tapeCassette tape MemoPrevention of condensation CondensationOver 10 years Power Power button/LED Cassette slotDUB Audio dubbing button/LED LineRemote Remote select switch MIC Microphone input terminalEject Eject button PINREC Record button/LED FF Fast forward button/LED Play Play button/LEDPause Pause button/LED @ Stop Stop button/LED$ Indicator Audio indicator Sensor for wireless remote controllerDC power input terminal 2P NTSC/PAL NTSC/PAL signal se- lection switchPIN Remote 9-pin remote ter- minal D-SUB It cannot be used for NTSC/PAL conversionAudio in Audio input terminal Terminal 4PNal Phono Video OUT S-VIDEO output termi Nal 4PPower button f Still Mode buttonButtons related to menu setting and variable speed playback Display buttonDUB button Pause button# F. ADV button $ F. REV buttonOn-screen display Contents Method ON-SCREEN Display Regarding on-screen displayContent ON-SCREEN DisplayStatus display MemoVTR operation mode ON-SCREEN Display Status displayTime code 00 00Display at position B Display for about 3 seconds Event displayDisplay at position a Operation in progress Alarm display Copy Inhibit REC InhibitDUB Inhibit REC TABPreparation Provided wireless remote controller Precautions on the use of batteryGuide on battery replacement When replacing the batteriesUsing the wireless remote controller Operable scope of the wireless remote controllerSensor for the wireless remote controller Maximum distance to the sensor of the unit 6m AnglePower Connecting to the AC adapterPreparation ScrewSwitching on the power Turning off the powerPreparation Selecting the NTSC/PAL signal system IndicatorEjecting the cassette Preparation Loading/ejecting cassettesLoading the cassette Preparation Setting/displaying date and time Setting the date and timeDisplaying the Clock Adjust menu Displaying the top MenuSet the date or time on the Clock Adjust menu To return to the usual menu, do the followingTime STYLE...Select the style of time display Selecting date/time displayEnabling on-screen display Connection and setting RecordingConnection RecorderSetting Setting time codes Preset time codesTime code is not preset Time code recordingRecording time codes of a DV input terminal Recording index signals Recording methodBackup unit the main unit Series recording functionDV Camcorder Set the DV TC DUP. item of the Time Code menu to OFFAudio dubbing Stop¥ The unit goes into the Still mode ¥ The unit goes into the audio dubbing pause modeHold down the A.DUB button and press the Pause button Press the Pause buttonConnection/setting Using this unit as a standalone deviceConnecting this unit to a video device with a DV terminal PlaybackAUDIO/VIDEO menu Remote switch on the front panelSystem menu Basic playback method Fast forward/rewindStill Mode item of the System menu Special playback functionFrame advance reverse playback Frame reverse in the reverse directionChanging the direction of playback Set the unit to the search modeVariable speed playback Locate function Index searchBlank search Stop mode, press the Blank buttonMIX Playback Selecting playback audio outputSelect the output level for audio play- back Using the unit in an editing system EditLinear editing system  Applicable modelPlay Delay Remote menuREM Stop SEL SynchronizationUsing the unit in a non-linear system Connecting using DV 1394 terminal Set the Input switch of the front panel to DV Remote switch on the front panel can be set at any positionMenu Screen Structure of the menuSetting the menu  Set the unit to the Stop modeDisplay the menu for setting Display the top MenuSet the items on the menu To return to the usual screen, do either of the followingPress the  button Press the REW button Select page Back MenuContents of the menus System menu  System menuMenu Screen Contents of the menus AUDIO/VIDEO menu Time Code menu Display menu  Display menuAudio Info  OFF Date StyleTime Style 12HOUR 24HOUROthers Placing the unit in an upright position Display Status Action  Alarm display Displayed regardless of the Display modeOthers  Warning display Displayed regardless of the Display mode Loading FailureTroubleshooting To return to the usual screen  To set the unit to the Stop modeChecking the hour meter Specification  Diagram of external dimension Unit mm 260 174Panasonic Broadcast Europe Panasonic Broadcast Europe GmbH