Panasonic VQT0C55 manual Recording method, Recording index signals

RECORDING – Recording method –

Remote controller

PAUSE button		REC button
	A.DUB PAUSE	REC
	F.REV	F.ADV
	PLAY
PLAY
button	REW	FF
	STOP
STOP	INDEX	INDEX
	–	+

button

VEQ3533

Memo

•If recording has been paused for an extended period of time, the unit will automatically go into the STOP mode to pro- tect the tape.

•This unit cannot perform editing functions.

Main unit

				REC	PLAY
				button	button
POWER
						EJECT
						MENU
		A.DUB		REC	PLAY	PAUSE
			DVCAM NTSC	PAL REC INH.			PAUSE
AG-DV2500			1 / 3
						SET	button
MIC	REMOTE	INPUT	CH	REW		FF
	OFF	LINE	2 / 4		STOP
			AUDIO
	9PIN WIRELESS	DV S-VIDEO

STOP button

1. Load the cassette.

•Before loading the cassette, please check that the rear slide of the cassette is pushed to REC.

¥ The Main unit is powered on.

2.Start recording.

•Hold down the REC button and press the PLAY button.

3.Pause recording.

•Press the PAUSE button.

4.Resume recording.

•Press the PAUSE button or press the PLAY button while holding down the REC button.

5.Stop recording.

•Press the STOP button.

Recording index signals

When the INDEX WRITE item of the SYSTEM menu is set as ON, an index signal is recorded at the starting position of re- cording.

In the PLAYBACK mode, the position where the index signal is recorded can be detected. (Index search)

⬛During recording, please press the REC button to record the index signal.

*Please allow at least an interval of 1 minute between recording of index signals.

Recording of index signals after tape recording is not possible.

Memo

Audio recording level

PCM audio recording level of DV-format VTRs can be divided into 2 main groups:

1)The group that uses full scale -20dB as the standard level, to which this unit belongs.

2)The group that uses full scale -12dB as the standard level.

When a tape recorded with this unit is played on a VTR based on full scale -12dB, the volume is decreased by about 8dB. This is not a malfunction.

E-37