Panasonic AJ-D450 manual Internal encoder adjustments, Video OUT REF BB, Recorder OUT, Monitor OUT

Internal encoder adjustments

In order to ensure error-free and accurate editing during AB roll editing (a method of editing using two source VTRs) using an editor, the ENCODER OUT controls must be adjusted after the system has been connected. (These controls must be re-adjusted each time the connecting cables are replaced or the connections are changed.)

Connect the equipment as shown in the figure below.

REF	P1 (AJ-D440)	REF	P2 (AJ-D440)	REF	Recorder (AJ-D750/AJ-D450)
(BB)		(BB)		(BB)
REF		REF		REF
VIDEO IN		VIDEO IN		VIDEO IN
	VIDEO 1		VIDEO 1		VIDEO IN
	OUT		OUT
	REF (BB)
	P1 IN		P2 IN
	REF IN	Switcher	RECORDER OUT		Make these three
			MONITOR OUT		cables equally long.
	Editing controller
		(AG-A850)

qThe external reference signal is

supplied from the sync signal generator to the equipment.

wComposite connections apply for the video signals.

TV	WFM	VSC
	(waveform
monitor		(vectorscope)
	monitor)

75Ω

If a waveform monitor and vectorscope are not available, correct any color shifting while actually monitoring the picture on the TV monitor.

– 18 –