Panasonic AJ-D440 manual Recording AJ-D450 only, 1Selecting video/audio input signals

Recording (AJ-D450 only)

1

2

3

4

Set the accidental erasure prevention tab on the cassette tape to the “recording” position and insert the tape.

Press the STOP button to place the unit in the stop mode.

Check that the REC INHIBIT lamp is off.

Select the video and audio input signals and adjust their levels.

4-1Selecting video/audio input signals

1Connect the signals to be recorded.

2Select the input signals using the INPUT SELECT switches on the front panel.

4-2Adjusting the audio level

5

6

Adjust the audio input signal levels of the analog audio CH1/CH2 signals. When set at the center position, audio signals will be recorded at the proper level.

Press the PLAY button while holding down the REC button. The REC and PLAY lamps light, and recording commences.

To end the recording, press the STOP button.

Recording is ended, and the unit goes into the stop mode.

<Notes>

•Check that the SERVO lamp is lighted during recording. If it flashes or if it is off, the images played back will be disturbed.

•The sound and pictures to be recorded are offset from the playback pictures by 5 frames and recorded. When, for instance, recording sound at a particular timing while the playback pictures are monitored, the sound to be edited will be recorded at a position which is offset from the playback pictures by 5 frames.

– 23 –