Panasonic AJ-D440, AJ-D450 manual Operation, Setting Description

USER menu

<OPERATION> (continued)

	Item		Setting
						Description
No.	Superimposed	No.		Superimposed
	display				display
109*	EJECT EE	0000			EE	This selects whether EE mode or BLACK is to be used during
	SEL	0001			BLACK	EJECT status.
						0: EE mode
						1: Video blackens, audio mutes.
110*	F/R EE SEL	0000			EE	This selects whether EE mode or playback mode is to be
		0001			TAPE	used during FF/REW operations.
						0: EE mode
						1: Playback mode
111*	STOP EE	0000			EE	This selects whether EE mode or playback mode is to be
	SEL	0001			TAPE	used during stop mode.
						0: EE mode
						1: Playback mode
						<Note>
						The STAND-BY OFF mode complies with the above selection.
						When TAPE is selected, however, the video becomes grey.
112	AUTO REW	0000			OFF	This selects whether to rewind the tape automatically to the
		0001			ON	tape start when the tape end is detected.
						0: The tape stops at the tape end.
						1: The tape is rewound to the tape start.
113	MEMORY	0000			OFF	This selects whether the VTR is to stop automatically when
	STOP	0001			ON	the counter value reaches “0” during a fast forwarding or
						rewinding operation in the CTL mode.
						0: The VTR does not stop.
						1: The VTR stops automatically.
						<Notes>
						1. The stop mode concerned is either the stop or the still-
						picture (SHTL STILL) mode depending on the setup menu
						No. 313 (AFTER CUE-UP) setting.
						2. When both the AUTO REW function and MEMORY
						function have been selected at the same time, the AUTO
						REW function takes precedence.
114*	REC	0000			OFF	This selects whether to allow (enable) or prohibit (disable) the
	INHIBIT	0001			ON	recording of signals on the cassette tape.
						0: Signals can be recorded on the cassette tape when the
						cassette’s accidental erasure prevention mechanism is
						set to the recording enable position.
						1: Recording on the cassette tape is prohibited. In this case,
						the REC INH lamp on the front panel lights.
115	STOP	0000			NORMAL	This selects the response when the mode is changed to
	RESPNS	0001			QUICK	STOP/STILL while the tape is traveling.
						0: Priority is given to the output picture.
						1: Priority is given to the response.
						<Notes>
						• At the 1 (QUICK) setting, the picture may not be as clear in
						the STOP/STILL mode as it would be at the 0 (NORMAL)
						setting.
						• CTL may shift by ±2 frames.

The underline on the setting item denotes the initial setting.

* The Setup menu can only be displayed for the model AJ-D450.

– 33 –