Controls and their functions (continued)
#0SET button
When this is pressed, the data which has been set on the setup menu is entered. After
data entry, the setup mode is exited and the original operating mode is restored.
#1DIAG button
When this is pressed, VTR information is displayed. When it is pressed again, the original
display is restored.
There are two types of VTR information: “HOURS METER” information and “WARNING”
information. Swithcing between these types is enabled by pressing the cursor buttons
( 
, 
).
Indicated on the “HOUR METER” screen are the
travel time, loading count, etc.
Indicated on the “WARNING” screen are the warnings.
#2VIDEO INPUT switch (AJ-D450 only)
This switches the video input signal.
DIGITAL: For selecting serial component digital video signal (SMPTE
recording.*
ANALOG: For selecting analog video signal recording.
Select the analog video signal as follows to correspond with the input signal.
Y PB PR: For recording an analog component video signal.
CMPST: For recording an analog composite video signal.
* The optional
#3AUDIO INPUT switch (AJ-D450 only)
This switches the audio input signal.
DIGITAL: For selecting serial digital audio signal (SMPTE 272M) recording.*1
AES/EBU: For recording a digital audio signal.*2
ANALOG: For recording an analog audio signal.
*1 Both the optional
audio interface board are necessary.
*2 The optional
#4REMOTE/LOCAL switch
This switch is set when the unit is to be controlled from an external source using the REMOTE connector or
REMOTE: Set to this position when controlling the unit by a device connected using the
LOCAL: Set to this position when controlling the unit using the controls on its own operation panel.
– 10 –