Panasonic AJ-D440, AJ-D450 manual Adjust the connected P2 VTR in the same way

1

2

3

Check the connections. (see previous page.)

Select [OFF] on ENCODER SEL at the set up menu. (See page 30.) Select [ON] to operate the internal encoder externally.

Adjust the SYSTEM PHASE.

3-1On the P1 VTR, play back a cassette tape on which standard color bar signals have been recorded.

3-2Adjust P1 VTR SYS PHASE.

Adjust the controls to the following with the waveform monitor (WFM).

1)Expand WFM 0.1 μs on the INT mode.

2)Check the H SYNC position.

3)In this status, select EXT mode for the WFM.

4)In EXT mode, adjust the SYSTEM PHASE to H, SC COARSE, SC FINE, in this order, at the set up menu to set H SYNC to its previous position.

■Waveform on waveform monitor

	INT mode
(Expanded to	EXT mode
0.1 μs)
	Adjust.

4

(Observe the SYNC fall.)

Adjust the connected P2 VTR in the same way.

– 19 –