Panasonic AJ-D450, AJ-D440 manual Video Setting Description

Setup menus

USER menu

<VIDEO> (continued)

	Item		Setting
							Description
No.	Superimposed	No.		Superimposed
	display				display
606	CC (F2)	0000			BLANK	This selects ON or OFF for the closed capture signal in the
	BLANK	0001			THRU	second field.
						0:	Forced blanking performed.
						1:	Blanking not performed.
608	FREEZE	0000			FIELD	This selects the freeze mode for still pictures.
	SEL	0001			FRAME	0:	Field freeze
						1:	Frame freeze
						<Note>
						When frame freeze is selected, the frame freeze mode is
						established even during slow motion.
611	EDH	0000			OFF	This selects whether to superimpose EDH onto the serial
		0001			ON	output signals.
						0: EDH is not superimposed.
						1:	EDH is superimposed.
						• This item setting is valid when the optional serial interface
						board has been installed.
612	WIDE	0000			AUTO	This selects the operation to be conducted in response to the
	SELECT	0001			WIDE	WIDE information.
		0002			NORMAL	0:	During recording, if the Y/C input signals contain WIDE
							information, the WIDE information is recorded on the tape.
							During playback, if WIDE information is on the tape, it is
							added to the Y/C output signals.
						1: During recording, the WIDE information is recorded on the
							tape regardless of whether the Y/C input signals contain
							the WIDE information.
							During playback, the WIDE information is added to the
							Y/C output signals regardless of whether the WIDE
							information is on the tape. → Forced WIDE ON
						2: During recording, the WIDE information is not recorded on
							the tape regardless of whether the Y/C input signals
							contain the WIDE information.
							During playback, the WIDE information is not added to the
							Y/C output signals regardless of whether the WIDE
							information is on the tape. → Forced WIDE OFF
						<Note>
						This item is effective during recording at the start of the
						recording and during playback at all times. Therefore, when
						its setting has been changed during recording, the MENU
						contents will be changed but no change will occur in the
						actual operation.
613	VIN SETUP	0000			THRU	This selects whether the composite signal is to be recorded
		0001			CUT	with setup or without setup.
						0: When recording signals with no setup.
						1: When recording signals with 7.5% setup.
						<Note>
						When recording composite signals, be sure to double-check
						whether the signals are to be recorded with or without setup.
614	VOUT	0000			THRU	This selects the composite output signal.
	SETUP	0001			ADD	0: The signal is output without setup.
						1: Ths signal is output with 7.5% setup.

The underline on the setting item denotes the initial setting.

– 40 –