16
basic features
Playback
before you start
Turn the TV on
Tune the TV to your Video Channel or to its
Playback is the most basic operation possible with your VCR.
Load a Video Cassette
Make sure that the window side of the cassette is facing up and the spine label is facing away from the VCR. Insert the cassette as shown in the diagram below; don’t use too much force. If the VCR was turned off before you inserted the cassette, the power will come on automatically.
AV mode
ntsc tapes
If an NTSC tape is played, ‘NTSCaPAL’ appears on screen for about 5 seconds
/ I |
|
|
|
VHS |
|
|
|
SAT |
|
| |
|
|
| PR |
| 1 3 | 2 | PUSH / TURN+ |
•If the record safety tab has been removed, playback begins automatically.
•If the record safety tab is intact, the VCR checks the tape information for Programme Navigation. For details, refer to ‘Programme Navigation’ (☞ pg. 39).
Some TVs will shrink the picture and place black bars at the top and bottom of the screen. This is not a malfunction but you may lose some
The picture may roll up or down. Correct this by adjusting the vertical hold on the TV set
The counter and tape remaining times will be incorrect
The picture will be distorted during search, still or
Play
If the cassette that you inserted does not start playing automatically, press the . button on the VCR or the Remote Control. ‘bESt’ appears blinking in the display panel during automatic tracking (☞ pg. 32).
•Playback picture quality of LP/EP recordings will not be as high as SP record- ings.
Stop & Eject
stop Press the §button on the VCR or the Sbutton on the Remote Control once to stop playback.
eject Press the §button on the VCR a second time to eject the cassette from the VCR. The cassette will take about 6 seconds to appear once the § button has been pressed.
NOTE: You can also eject the cassette while the VCR is turned off.