JVC RX-774RBK One Touch Operation, To store the sound settings, To recall the sound settings

One Touch Operation

This receiver can memorize the optimum sound settings for each playing source.

English

About the One Touch Operation

JVC’s One Touch Operation function is used to assign and store different sound settings for each different playing source. By using this function, you don’t have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled.

The following can be stored for each source:

•Volume level (see page 21)

•Balance (see page 23)

•Loudness (see page 23)

•SEA modes (see page 36)

•DSP modes

–3D-PHONIC mode settings (see page 39)

–DAP mode settings (see page 41)

–Surround mode settings (see page 44)

•DVD MULTI playback mode settings (see page 49)

Using the One Touch Operation

On the front panel only:

To store the sound settings

1. Press ONE TOUCH OPERATION. ONETOUCHOPERATION

The ONE TOUCH OPERATION lamp lights up, then the previously memorized settings are recalled.

2.Adjust the sound using the functions listed above. The newly adjusted settings are memorized.

To recall the sound settings

With the ONE TOUCH OPERATION lamp lit, the settings	ONETOUCHOPERATION
for the currently selected source is recalled, when the
source is selected.

To cancel the One Touch Operation function

Press ONE TOUCH OPERATION so that the lamp goes off.

(Even though the One Touch Operation function is canceled, the recalled sound effects remain active.)

Notes:

•If the source is FM or AM (MW/LW), you can assign a different setting for each band.

•The DSP modes and DVD MULTI playback mode cannot be used at the same time.

26