JVC RX-774RBK manual Using the DVD Multi Playback Mode, Keys are activated for adjusting the sound

Using the DVD MULTI Playback Mode

English

	IMPORTANT:
AUDIO/TV	When using the Remote Control, check to see if its remote control
/VCR	mode selector is set to the correct position:
/DBS	To operate this receiver, set it to “AUDIO/TV/VCR (except when
CATV
	selecting the DBS tuner as the source).”

From the remote control:

1.Press DVD MULTI so that “DVD MULTI” appears on the display.

Each time you press the button, the source alternates between “DVD” and “DVD MULTI.”

2.Select the analog discrete output mode on the DVD player, and start playing a DVD.

• Refer to the manual supplied with the DVD player.

If you need to make any adjustment, go to the following steps.

3.Press SOUND CONTROL.

10 keys are activated for adjusting the sound.

4.Press CNTR +/– to adjust the center speaker output level.

•Pressing CNTR – decreases the output level up to –10 dB.

•Pressing CNTR + increases the output level up to +10 dB.

5.Press REAR•(L) +/– to adjust the left rear speaker output level.

•Pressing REAR•(L) – decreases the output level up to –10 dB.

•Pressing REAR•(L) + increases the output level up to +10 dB.

6.Press (REAR•R) +/– to adjust the right rear speaker output level.

•Pressing (REAR•R) – decreases the output level up to –10 dB.

•Pressing (REAR•R) + increases the output level up to +10 dB.

7.Press CENTER TONE to select the center tone level. Each time you press the button, the display changes to show the following:

DVD MULTI

SOUND

CONTROL

CNTR MENU

2 3

ENTER REAR(L)

5 6

(REARR)

8 9

CNTR TONE

1

Note:

You cannot adjust the center speaker level when “CENTER SPK” is set to “NONE” (see page 24).

Note:

You cannot adjust the left rear speaker level when “REAR SPK” is set to “NO” (see page 25).

Note:

You cannot adjust the right rear speaker level when “REAR SPK” is set to “NO” (see page 25).

Note:

The center tone cannot be adjusted when “CENTER SPK” is set to “NONE” (see page 24).

SOFT2 SOFT1 FLAT SHARP1 SHARP2

To make the dialogue clearer, select “SHARP1” (little) or “SHARP2” (much). To make the dialogue softer, select “SOFT1” (little) or “SOFT2” (much). When “FLAT” is selected, no adjustment is applied.

51