JVC HR-E249E Initial Settings, If both auto channel set and auto clock set have failed

6EN

INITIALSETTINGS(cont.)

If both auto channel set and auto clock set have been performed successfully:

1 Perform "Video Channel Set" on page 8.

2 Turn on the TV and select its VIDEO channel or AV mode, then make sure that all necessary stations have been stored in the recorder's memory by using the TV PROG. button(s).

●If station names (ID — ☞ pg. 40) have also been stored in the recorder's memory, the station name will be displayed at the top left corner of the screen for about 5 seconds when the recorder is tuned to a different station.

●If you want to set the tuner manually such as to add or skip channels, to change channel positions, or to set or change station names, see pages 38 – 39.

3 Perform "SHOWVIEW Setup" on page 10 to check if the Guide Program numbers have been set correctly.

If auto channel set has succeeded but auto clock set has not:

1 Perform "Video Channel Set" on page 8.

2 Turn on the TV and select its VIDEO channel or AV mode, then make sure that all necessary stations have been stored in the recorder's memory by using the TV PROG. button(s).

●If station names (ID — ☞ pg. 40) have also been stored in the recorder's memory, the station name will be displayed at the top left corner of the screen for about 5 seconds when the recorder is tuned to a different station.

●If you want to set the tuner manually such as to add or skip channels, to change channel positions, or to set or change station names, see pages 38 – 39.

3 Perform "Clock Set" on page 41, then "SHOWVIEW Setup" on page 10 to check if the Guide Program numbers have been set correctly.

If both auto channel set and auto clock set have failed:

1 Make sure the TV aerial cable is connected properly to the recorder and turn off the recorder power once, then turn the recorder power back on again.

●The Country Set display appears on the front display panel and/or on the screen; perform steps 2 and 4 on pages 4 – 5 again.

IMPORTANT

●Depending on the reception conditions, the station names may not be stored correctly, and auto Guide Program Number Set may not work properly. If the Guide Program numbers are not set properly, SHOWVIEW timer recording (☞ pg. 24) will not work correctly; be sure to check if the Guide Program numbers have been set correctly (☞ pg.10, "SHOWVIEW Setup").

●Since your video recorder memorizes all detected stations even if the reception condition is poor, some of those stored stations may produce a noisy picture. To delete those stations, ☞ "Delete A Channel" on page 38.

INFORMATION

Language for the on-screen display

Auto Set Up also selects the language automatically for the on-screen display depending on the Country setting you have made in step 2 on page 4 (unless you have selected BELGIUM or SUISSE), as shown below.

SUOMI	[ SUOMI	SVERIGE	[ SVENSKA	ESPAÑA	[ CASTELLANO
PORTUGAL	[ ENGLISH	DANMARK	[ DANSK	NEDERLAND	[ NEDERLANDS
DEUTSCHLAND	[ DEUTSCH	ÖSTERREICH	[ DEUTSCH	GREECE	[ ENGLISH
NORGE	[ NORSK	ITALIA	[ ITALIANO	OTHERS	[ ENGLISH

If you want to change the language setting manually, ☞ "Language" on page 7.

Just Clock

Your recorder is equipped with the Just Clock function which provides accurate time keeping through automatic adjustments at regular intervals, by reading data from a PDC signal. If you want to take advantage of this function, simply set it to "ON".

☞"Just Clock" on page 41.