Magnavox MDV560VR Additional Information DVD, Screen Saver, Last Condition Memory DVD VCD1.1

English

34 Operation

Additional Information - DVD

Screen Saver

The screen saver picture appears when you leave the DVD+VCR in stop mode for about fifteen minutes.

Last Condition Memory DVD VCD1.1

This player memorizes the user settings for the last disc that you have viewed. Settings remain in memory even if you remove the disc from the player or switch off the player. If you load a disc that has its settings memorized, the latest stop position is automatically recalled.

Notes

∀Settings are stored in memory for use any time.

∀This player does not memorize settings of a disc if you switch off the player it plays.

Video Mode Setting DVD VCD2.0 VCD1.1

Note

The video mode setting only works when the Progressive Scan mode is set to “On” on the setup menu.

∀With certain discs, the playback picture may be flickering or Dot Crawl is shown on straight lines. (This means Vertical interpolation or De-interlace is not perfectly matched with the disc.) In this case, the picture quality may be improved by changing the video mode.

∀To change the video mode, press and hold DISPLAY about 3 seconds during disc playback. The new video mode num- ber selected is displayed on the TV screen. Check whether the video quality has improved. If not, repeat the above procedure until picture quality is improved.

∀Video mode sequence:

MODE1 → MODE2 → MODE3 → MODE1

∀If you turn off the power, the video mode will return to initial default state (MODE1).

Detailed Description of each Video Mode

MODE1 : The source material of the DVD video (film material or video material) is determined from disc information.

MODE2 : Suitable for playing film based content or video based material recorded by the progressive scan method.

MODE3 : Suitable for playing video based content with comparatively little motion.