Furuno RP-25 manual Chart Cards, Displaying chart cards, Card slot location

Page 17

2.2Chart Cards

WARNING

Chart cards are intended as an aid to navigation. The navigation has the responsivility to check all aids available to confirm position.

2. VIDEO PLOTTER

CAUTION

Handle chart cards and memory cards with care.

Keep cards away from direct sunlight, heat sources, and active gases.

Keep cards away from water and chemicals.

Keep the connector free foreign material.

Do not drop the cards.

2.2.1Displaying chart cards

To display a chart;

1. Insert chart card in left side slot of the two chart card drive.

Eject button

for right card drive

Card Drive

Right: RAM card

Left: Chart card

Eject button

for left card drive

Display unit

Card slot location

2.Press the [POWER] button to turn the power on. The chart data appears (NU, CU, TM modes only).

When a chart card is inserted after turning the power on, press the [RANGE +/-] key to change the range. The chart data appears.

2-3

Image 17
Contents Video Plotter 00080745701 Safety Instructions Word to RP-25 Owners FeaturesForword Your 2805 spec Radar map Video plotter IiiTable of Contents Initial Settings Key panel right side Radar MAPKeys for radar map Radar map menu PreparationEnter mark menu Making a Radar MapSelecting the entering way Enter Mark menu on selecting L/L Shapes for linesLongitude/Latitude OWN Ship Posn Positon Erasing Contents of the Radar Map Radar map correction Position and bearing correctionCursor data correction Releasing the radar map correctionOverview Video PlotterKeys for video plotter Selecting DisplaysTrue motion automatic return Display modesSample video plotter display Card slot location Chart CardsDisplaying chart cards Canceling chart correction Chart position correctionAdding correcting value to cursor data Video plotter 2 menuSetting the navigation data Setting up the Video PlotterHiding/showing graphics Display select menuNav information 1 menu Nav information 3 menu Nav information 2 menuRecording the own ship’s track TrackOwn track plot interval and storage time Own ship plot, target plot menuOther target plot interval and storage time Recording other ship’s trackSmoothing Erase menu Erasing trackSelecting method of entry Marks, LinesEntering mark Selecting mark Entering independent lines Entering lineErasing marks/lines on a area Erasing Marks, LinesErasing individual marks/lines Erasing all marks Entering waypoints WaypointsEntering waypoints by the cursor Enter wpt, nav line menuEntering waypoints at own ship’s position Waypoint listWpt list menu WPT List Enter WPT, NAV LineWay point menu on selecting video plotter Displaying a waypointInternal storage waypoint Way point menu on selecting navigation External waypointEntering navigation line Navigation LinesEntering new navigation line Enter nav line menuRemoving waypoints from navigation lines Navigation line listAdding waypoit to navigation lines Deleting all navigation lines Deleting navigation linesDeleting individual navigation lines Nav line menu Video plotter mode Setting up the navigation linesPress the Enter key Press the NAV Menu key to close the menu Displaying navigation lines Recording and Replaying DataFormatting memory RAM card Internal navigation linesRecord card menu Recording dataReplay card menu Replaying dataVideo plotter initial setting menu Maintenance for TechniciansInitial Settings Do not open the equipment Replacement of Battery on RP BoardAP-1 Menu TreeAP-2 AP-3 Latitude Error Table on 96 NM RangeSP-1 Specifications