JVC SR-MV50U manual When using this unit as the recording deck

64 EN EDITING

	Edit To Or From Another Recorder	Slide the TV/CABLE/DBS/DVD switch to DVD.
		1 Make connections.
You can use your unit as the source player or as the recording
		When using this unit as the recording deck
deck.
		A If the another recorder has no S-VIDEO connector, connect the

NOTE:	unit’s [AUDIO/VIDEO INPUT] connectors to the audio/video output
When using another recorder as the recording deck, refer to its	connectors on another recorder.
instruction manual.	B If the another recorder has S-VIDEO connector, connect the
	[AUDIO INPUT] and [S VIDEO INPUT] connectors to the audio
Your unit	and S-video output connectors on another recorder.
	● If connecting a unit with an S-VIDEO connector, it is recommended to
	use the supplied S-Video cable to minimize picture degradation while
	editing.
.	2 Press VCR/DVD repeatedly to select the recording deck.
Recorder
	3 Press CH +/– to select “L-1” when using this unit as the
TV receiver
	recording deck.
	● Set “REAR AUX L-1” to “VIDEO” for the VIDEO input connector, or
	“S-VIDEO” for the S-VIDEO input connector, depending on the
	connector being used. ( pg. 70) This setting is also applied to the
	VCR deck.
	4 For VCR deck only
	Set “PICTURE CONTROL” to the appropriate mode. ( pg. 72)
	5 Press REC MODE repeatedly to set the recording mode.
	6 Engage the Play mode of the source player.
	7 Engage the Record mode of the recording deck.
Another recorder	8 Stop recording on the recording deck, then stop playback on the
	source player.
Player	NOTES:
	● All necessary cables can be obtained from your dealer.
	● When you use this unit as the source player for editing, be sure to set
	“SUPERIMPOSE” to “OFF” before starting. ( pg. 70)
	● When you select “EDIT” to dub tapes in step 4, be sure to select
	“AUTO” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”)
	after you finish dubbing the tapes.