JVC DR-M70SEK manual Installing batteries in the remote control, About the remote control

Page 11

20RETURN button

Press to return to the previously displayed menu screen.

21B (SKIP) button

During playback, press to skip to the previous chapter or track.

When playback is paused, press to play reverse step by step.

F(SKIP) button

During playback, press to skip to the next chapter or track.

When playback is paused, press to advance step by step.

22PLAY P button*

Press to start or resume playback.

23SLOW /REV r button

During playback, press to reverse fast.

When playback is paused, press to reverse slowly.

SLOW /FWD f button

During playback, press to forward fast.

When playback is paused, press to forward slowly.

24PAUSE p button

Press to pause playback or recording.

25STOP S button*

Press to stop playing back or recording.

Button names described in the Instruction Manual

The instructions in this manual are described mainly with the operations using the remote control. Some operations can be carried out using the buttons on the front panel.

Installing batteries in the remote control

Install two R6 (AA) batteries (supplied) into the remote control, carefully match with the polarity indicated inside the battery compartment.

1

2

3

Caution

Incorrect use of batteries can result in hazards such as leakage and bursting.

Do not mix new and old batteries together.

Do not use different kinds of batteries together.

Make sure that the plus and minus ends of each battery match the indications inside the battery compartment.

Remove batteries if the equipment will not be used for a month or more.

When disposing used batteries, please comply with governmental regulations or the public instructions for environmental protection that apply in your country or area.

Do not recharge, short-circuit, heat, burn or disassemble batteries.

About the remote control

Make sure there is no obstacle between the remote control and the remote control sensor on the unit.

Use within the operating range and angle as shown.

Within about 7 m

60˚

Remote control

Remote control operation may become unreliable if the remote control sensor of the unit is being exposed by the strong sunlight or fluorescent light.

Remote controls for different devices can interfere with each other. Be careful when using remote controls for other equipment located close to the unit.

Replace the batteries when the operating range of the remote control reduces.

Before you start

EN 11

Image 11
Contents Manufactured under license from Video Plus+ and PlusCode are registeredTrademarks of Gemstar Development Corporation. The Video Plus+ system isAccessories Supplied PrecautionsLaser Safety Power SupplyAbout Copyright Installation LocationAvoid the Hazards of Electrical Shock and Fire Moisture Condensation WarningMains Cord Connection to PowerMaintenance Table of contents Editing FeaturesRecording PlaybackSymbol Description Front panel Functional overviewRear panel Remote control About the remote control Installing batteries in the remote controlDisplay menu Setting menusEasy Setting Menu Guide to On Screen DisplaysAdvanced Setting Menu Display messages Front Panel Display GuideConnections Connecting to a TVConnecting to external equipment Using the S-VIDEO OUT jack and the Analog Audio OUT jackConnections illustrated above are optional for better sound Connecting to an MD deck or DAT deckDigital audio for better sound quality After you have completed connectionsPress SET UP to exit Channel settingAuto tuning Manual tuningMove To skip a Preset channelAfter completion, press SET UP to exit To select a channelHint Setting the clockClock Setting Selecting the TV aspect ratioRestrictions on recording Information on DVD recordingType of discs Recording speedUsable discs FeaturesInformation on copy control Making discs playable in other DVD players FinaliseChoosing the recording format of a blank DVD-RW disc Setting Auto ChapterFormatting a disc Reformatting a disc manually Selecting the Sound modeSetting External input audio Insert a recordable disc Stop mode, press SET UPPress Stop S to stop the recording Setting Bilingual Recording AudioBasic recording Turn on the unit and insert a recordable discREC Speed repeatedly One-touch timer recording OTRChecking the recording picture and sound quality Press REC Monitor again to exitPress STANDBY/ON y/I Timer recordingEnter the date using Cursor U / D, then press Cursor P Press Enter when all information required is enteredPress Clear to erase the selected programme If the timer programming did not complete correctlyError number appears on the timer programming list Error numbers indicateOverlap is displayed if Timer recording using the Video Plus+ systemCode Error is displayed if Stop mode, press the Video Plus+ buttonIf the recording time is partially overlapped Hints for timer recordingPriority of overlapped settings If the starting time is sameRecording from external equipment Settings for external equipmentConnection to external equipment Finalising will start Finalising discsFinalising is complete To cancel finalising DVD-RW onlyAuto finalise Region codes Information on playing back DVDsPlayable discs Colour systemsPlaying back a DVD-Video / CD / Video CD Basic playbackHint for DVD playback Playing back a DVD-RW / DVD-R DVD+RW / DVD+R discPress MENU/LIST to exit the disc menu Playing back discs using the disc menuSelect an item using Cursor U / D / L / P, then press Enter Press MENU/LISTPBC function for Video CDs Playing back a disc using the title menuPlaying back a Video CD using the title menu Fast forward / Fast reverse Cancelling and Recalling the PBC functionSpecial playback Resume playbackSlow forward / Slow reverse playback Skipping TV commercials during playbackPause Step by step playbackDuring playback, press Zoom Marker SetupZoom Direct Search SearchTitle / Chapter search Track searchRepeat playback Repeat / Random / Program playback / Slide ShowTime search Slide Show Select Random Play using Cursor U / D, then press EnterRandom playback Program playbackPress Audio during playback, and follow from step Switching audio soundtrackSwitching subtitles Selecting the format of audio and videoReducing block noise Switching camera anglesSelect the icon using Cursor L / P, then press Enter Angle will switch each time you press EnterDeleting titles Editing discs in Video modeDisc editing Guide to a title listWindow for entering the title name will appear Editing titlesGuide to editing title names Follow steps 1 to 4 in Deleting titlesPress SET UP Setting or clearing chapter markersEditing original titles Original Editing discs in VR modeOriginal Editing Original titles in VR mode Original Deleting titlesFollow steps 1 to 4 Original Protecting titles Press Enter To protect a whole disc DVD-RW VR mode onlyOriginal Protecting titles Original Releasing titles from protectingPlaylist Deleting parts of titles Scene Delete Playlist Editing the Playlist in VR modePlaylist Deleting titles Deleting a chapter marker Playlist Setting or clearing chapter markersPlaylist Editing titles Adding a chapter markerYou can divide a title into two new titles Playlist Setting pictures as thumbnailsPlaylist Dividing a title Picture is set as the thumbnailPlaylist Deleting a Playlist Select Yes using Cursor L / P, then press EnterPlaylist Combining titles Playlist Adding titles to a PlaylistTour of the Setting menu Changing the Setting menuSubtitle Language Default OFF Language settingDisc Menu Language Default English Audio Language Default OriginalScreen Saver Default 10 minutes Display settingAudio setting FL Dimmer Default AutoSettings for Mpeg Default PCM Dynamic Range Control Default onFast Forward with Audio Default on Dolby Digital conversion Default StreamPassword is already set Parental Lock Default AllEnter the current password using the Number buttons Password is not yet setChanging Video Out system Setting TV systemSymptom Remedy TroubleshootingStop S ALL Error message Cause SolutionLanguage Code Language codeGlossary Recording SpecificationsDeclaration of Conformity General66 EN Page DR-M70SEK