Dynamic Range Control Default on | JVC DR-M70SEK specification

Note

When playing back a disc with copyright protection:

•Even if you select “96kHz,” the sound is down sampled to 48 kHz.

Dolby Digital conversion (Default: Stream)

Digital Out - Dolby Digital

PCM

Stream

Select a setting using

[Cursor U / D], then press [ENTER].

Your setting is activated.

PCM: Converts the Dolby Digital into PCM (2 channel).

If your amplifier / decoder is NOT compatible with Dolby Digital, set to “PCM”.

Stream: Outputs Dolby Digital signals.

If your amplifier / decoder is compatible with Dolby Digital, set to “Stream”.

Hint

When playing back a DVD-RW disc recorded in VR mode:

•If the audio source on a disc is in Dolby Digital format, set “Dolby Digital” to “PCM” so that you can switch to main audio (L), sub audio (R), or a combination of both (L / R) using your amplifier / decoder.

Settings for MPEG (Default: PCM)

Digital Out - MPEG

PCM

Stream

Select a setting using

[Cursor U / D], then press [ENTER].

Your setting is activated.

PCM: Converts MPEG into PCM.

If your amplifier / decoder is NOT compatible with MPEG, set to “PCM.”

Stream: Outputs MPEG Audio signals.

If your amplifier / decoder is compatible with MPEG, set to “Stream.”

Settings for DTS (Default: ON)

Digital Out - DTS

OFF

Select a setting using

[Cursor U / D], then press [ENTER].

Your setting is activated.

ON: Outputs DTS signals.

If your amplifier / decoder is compatible with DTS, set to “ON.”

OFF: No DTS signal is output.

If your amplifier / decoder is NOT compatible with DTS, set to “OFF.”