JVC DR-M70SEK manual Connection to Power, Maintenance, Mains Cord

Page 4

Before you start

Connection to Power

Before Switching on make sure that the voltage of your electricity supply is the same as that indicated on the rating plate.

Mains Cord

This appliance may be fitted with a non-rewireable plug. If it is necessary to change the fuse in a nonrewireable plug the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug must not be used until a replacement available from the appliance manufacturer is obtained.

It is important that the colour of the replacement fuse cover corresponds with the rating marking on the base of the plug.

If the plug has to be changed because it is not suitable for your socket, or becomes damaged, it should be cut off and an appropriate plug fitted following the wiring instructions below. The plug removed must be disposed of safely as insertion into a 13A socket is likely to cause an electrical hazard. For your own safety read the following instructions carefully before attempting to connect this unit to mains.

The wires in this mains lead are coloured in accordance with the following code:

BLUE=NEUTRAL, BROWN=LIVE

Important

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:-

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

No connection is to be made to the earth terminal of the plug.

If a 13 Amp (BS 1363) Plug is used, a 3 Amp Fuse must be fitted, or if any other type of Plug is used a 3 or 5 Amp Fuse must be fitted, either in the Plug or Adaptor, or on the Distribution Board.

Mains Supply:220 - 240 V 50 Hz - AC only

Do not make any connection to the larger pin marked with the letter “E” or by the symbol or coloured green or green and yellow.

Maintenance

CLEANING THE UNIT

Use a soft cloth slightly moistened with a mild detergent solution. Do not use solutions containing alcohol, spirits, ammonia or abrasive.

CLEANING DISCS

If a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the centre out. Do not wipe in a circular motion.

Do not use solvents such as benzine, thinner, commercially available cleaners, detergent, abrasive cleaning agents or antistatic spray intended for analogue records.

DISC HANDLING

Handle the discs so that fingerprints and dust do not adhere to the disc surfaces.

Always store the disc in its protective case when it is not in use.

SERVICING

If the unit becomes inoperative, do not try to correct the problem by yourself. There are no user serviceable parts inside. Turn the unit off, unplug the mains cable, and consult your dealer or an authorized service centre.

CLEANING THE DISC LENS

If the unit does not perform correctly even though you have referred to “Troubleshooting” and the relevant sections in the Instruction Manual, the laser optical pickup unit may be dirty. Consult your dealer or an authorized service centre for inspection and cleaning of the laser optical pickup unit.

BLUE

(Neutral)

FUSE

BROWN

(Live)

CORD GRIP

OUTER SHEATH OF THE WIRE

4 EN

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Video Plus+ and PlusCode are registered Trademarks of Gemstar DevelopmentCorporation. The Video Plus+ system is Manufactured under license fromPrecautions Laser SafetyPower Supply Accessories SuppliedInstallation Location Avoid the Hazards of Electrical Shock and FireMoisture Condensation Warning About CopyrightMaintenance Connection to PowerMains Cord Table of contents Features RecordingPlayback EditingSymbol Description Functional overview Front panelRear panel Remote control Installing batteries in the remote control About the remote controlSetting menus Easy Setting MenuGuide to On Screen Displays Display menuAdvanced Setting Menu Front Panel Display Guide Display messagesConnecting to a TV Connecting to external equipmentUsing the S-VIDEO OUT jack and the Analog Audio OUT jack ConnectionsConnecting to an MD deck or DAT deck Digital audio for better sound qualityAfter you have completed connections Connections illustrated above are optional for better soundChannel setting Auto tuningManual tuning Press SET UP to exitTo skip a Preset channel After completion, press SET UP to exitTo select a channel MoveSetting the clock Clock SettingSelecting the TV aspect ratio HintInformation on DVD recording Type of discsRecording speed Restrictions on recordingFeatures Information on copy controlMaking discs playable in other DVD players Finalise Usable discsFormatting a disc Setting Auto ChapterChoosing the recording format of a blank DVD-RW disc Selecting the Sound mode Setting External input audioInsert a recordable disc Stop mode, press SET UP Reformatting a disc manuallySetting Bilingual Recording Audio Basic recordingTurn on the unit and insert a recordable disc Press Stop S to stop the recordingOne-touch timer recording OTR Checking the recording picture and sound qualityPress REC Monitor again to exit REC Speed repeatedlyTimer recording Enter the date using Cursor U / D, then press Cursor PPress Enter when all information required is entered Press STANDBY/ON y/IIf the timer programming did not complete correctly Error number appears on the timer programming listError numbers indicate Press Clear to erase the selected programmeTimer recording using the Video Plus+ system Code Error is displayed ifStop mode, press the Video Plus+ button Overlap is displayed ifHints for timer recording Priority of overlapped settingsIf the starting time is same If the recording time is partially overlappedConnection to external equipment Settings for external equipmentRecording from external equipment Finalising discs Finalising will startAuto finalise To cancel finalising DVD-RW onlyFinalising is complete Information on playing back DVDs Playable discsColour systems Region codesBasic playback Hint for DVD playbackPlaying back a DVD-RW / DVD-R DVD+RW / DVD+R disc Playing back a DVD-Video / CD / Video CDPlaying back discs using the disc menu Select an item using Cursor U / D / L / P, then press EnterPress MENU/LIST Press MENU/LIST to exit the disc menuPlaying back a Video CD using the title menu Playing back a disc using the title menuPBC function for Video CDs Cancelling and Recalling the PBC function Special playbackResume playback Fast forward / Fast reverseSkipping TV commercials during playback PauseStep by step playback Slow forward / Slow reverse playbackZoom Marker SetupDuring playback, press Zoom Search Title / Chapter searchTrack search Direct SearchTime search Repeat / Random / Program playback / Slide ShowRepeat playback Select Random Play using Cursor U / D, then press Enter Random playbackProgram playback Slide ShowSwitching audio soundtrack Switching subtitlesSelecting the format of audio and video Press Audio during playback, and follow from stepSwitching camera angles Select the icon using Cursor L / P, then press EnterAngle will switch each time you press Enter Reducing block noiseEditing discs in Video mode Disc editingGuide to a title list Deleting titlesEditing titles Guide to editing title namesFollow steps 1 to 4 in Deleting titles Window for entering the title name will appearSetting or clearing chapter markers Press SET UPEditing discs in VR mode Original Editing Original titles in VR modeOriginal Deleting titles Editing original titles OriginalTo protect a whole disc DVD-RW VR mode only Original Protecting titlesOriginal Releasing titles from protecting Follow steps 1 to 4 Original Protecting titles Press EnterPlaylist Deleting titles Playlist Editing the Playlist in VR modePlaylist Deleting parts of titles Scene Delete Playlist Setting or clearing chapter markers Playlist Editing titlesAdding a chapter marker Deleting a chapter markerPlaylist Setting pictures as thumbnails Playlist Dividing a titlePicture is set as the thumbnail You can divide a title into two new titlesSelect Yes using Cursor L / P, then press Enter Playlist Combining titlesPlaylist Adding titles to a Playlist Playlist Deleting a PlaylistChanging the Setting menu Tour of the Setting menuLanguage setting Disc Menu Language Default EnglishAudio Language Default Original Subtitle Language Default OFFDisplay setting Audio settingFL Dimmer Default Auto Screen Saver Default 10 minutesDynamic Range Control Default on Fast Forward with Audio Default onDolby Digital conversion Default Stream Settings for Mpeg Default PCMParental Lock Default All Enter the current password using the Number buttonsPassword is not yet set Password is already setSetting TV system Changing Video Out systemTroubleshooting Symptom RemedyStop S Error message Cause Solution ALLLanguage code Language CodeGlossary Specifications Declaration of ConformityGeneral Recording66 EN Page DR-M70SEK
Top Page Image Contents