JVC DR-M70SEK manual If the timer programming did not complete correctly, Error numbers indicate

• [STOP S]

on the remote control is not effective.

1 Press [STANDBY/ON y/I] so that the

icon disappears from the front panel display.

2 Press [PROG] twice.

Timer programming list will appear.

3 Check the information on the list you will need.

4 To clear the timer programming, select the desired programme using [Cursor U / D], then press [CLEAR].

To correct the timer programming

1) Select the desired programme using [Cursor U / D], then press [ENTER].

2) Correct the timer programming using [Cursor U / D / L / P].

3) Press [ENTER] again.

5 Press [PROG] to exit.

6 Press [STANDBY/ON y/I] to return to the timer-standby mode.

To check the timer programming in progress Press [PROG].

Note

• If a timer recording is proceeding, that programme is highlighted in red. In such a case, you cannot select any other programmes.

To stop the timer recording in progress

Press [STOP S] on the front panel of the unit.

Note

Checking, cancelling, or correcting the timer programming information

In the following example, No. 5 timer programming overlaps on No. 1 and No. 6 timer programmes. In such a case, you should correct the programme time to clear the overlap.

Timer Programming

Date	Start	End	CH	Speed
1. 01/01	12:00	13:00	AV3	XP
2. - - -

3.	- - -		Overlap
4. - - -			No.1 6
5. 01/01		12:30	14:00	P02	SP
6. 01/01		13:45	21:00	P12	SEP
7.	- - -
8.	- - -

If the timer programming did not complete correctly

The error number appears on the timer programming list.

Timer Programming

Date	Start	End	CH	Speed
01/01	12:00	13:00	AV3	E1

2.- - -

3.- - -

4.- - -

5.- - -

6.- - -

7.- - -

8.- - -

The error programme will be displayed in grey with an asterisk and have an error number.

The error numbers indicate:

E1–E22, E37–E39: Recording error

E23–E24: Unrecordable disc E25:•Copy prohibited programme

•Cannot record because of the NTSC / PAL- 60 signal is received.

E26–E28: Copy prohibited programme

E29: Disc protected

E30: Disc full

E31: Already recorded 99 titles (Video mode)

E32: Already recorded 99 titles (VR mode)

E33: Already recorded 999 chapters

E34: No space for Control Information

E35: PCA (Power Calibration Area) full

E36: Already finalised Video format disc E40:•There are some unrecorded parts due the

overlapped timer programmes. •Recording did not start at the start time.

E41: Power failure

E42: No disc

The error programme will be deleted once you check the error in the programme list, or once you cancel the timer-standby mode and re-enter it.

Press [CLEAR] to erase the selected programme.

Recording

EN 27