Commercial Mode Setup for Master TV

This section describes how to set up a Master TV for cloning purposes when the TV is in Pass-through Mode.

Note: Disconnect all Aux inputs. Under certain conditions, Auto Tuning (Channel Search) is disabled if there is an Aux input active.

Note: Refer to FTG Mode information on pages 29 to 37 for information on entering FTG Mode and config- uring/editing FTG Channel Map and FTG Installer Menu settings using the FTG Configuration Application.

1.Set Installer Menu items.

This step provides specific instruction only on the Installer Menu items that should be set on a Master TV. Refer to pages 14 to 20 for detailed information on all Installer Menu items.

a)Make sure the TV is ON. Then, use the Installer Remote to enter the TV Installer Menu: Press MENU repeatedly until the on-screen setup menus lock up, and then press 9-8-7-6+

ENTER.

b)Set Installer Menu item 117 FACT DEFAULT to 001 and press ENTER on the Installer Remote.

This clears all Installer Menu custom settings, the channel lineup, etc. and reloads the factory default settings. The value will change back to 0 after the internal TV controller (Protocol Translator Card [PTC]) has been restored to factory default condition. This step ensures that the TV Channel Memory will be the active channel lineup.

c)Set Installer Menu item 003 BAND/AFC, as appropriate.

•	Broadcast: Set to	000.	•	HRC: Set to 002.
•	CATV: Set to 001	(default).	•	IRC: Set to 003.

d)Set any other Installer Menu items that affect your TV program- ming network to the required configuration. For example, enable/ disable Aux sources, set a Start Channel, etc.

e)After you have adjusted all required Installer Menu item settings, press ENTER once on the Installer Remote to save your changes; then, press ENTER again to exit the menu.

2.Set up TV features.

On-screen setup menus control the features of the TV (see page 21). Press MENU on the Installer Remote to access the setup menus, and then set Channel, Picture, Audio, Lock, Time, etc. options to the desired configurations. See also the Clonable Menu Features list on page 23.

Note: If desired, you can run Auto Tuning (see step 3) prior to completing this step.

3.Run Auto Tuning (Channel Search).

xxLD330H PTC INSTALLER MENU

000	INSTALLER SEQ	000

UPN	000-000-000-000	ASIC 20E7
PTC	V1.00.001	CPU V3.06.00

Typical TV Installer Menu

Note: The Installer Menu header will vary depending on the TV you are setting up.

117	FACT DEFAULT	001
003	BAND/AFC	00X

Adjust the settings for these

Installer Menu items.

CHANNEL	PICTURE	AUDIO	TIME
LOCK	OPTION	INPUT	MY MEDIA

Set the TV features to the desired

configuration for the end user.

a)Search for all available analog and digital channels: Go to the Channel Menu, select the Auto Tuning option, and follow the on-screen instructions.

(Continued on next page)

206-4185