LG Electronics 37LD330H, 32LD330H setup guide Verify the TV setup, Lock the channel lineup

Commercial Mode Setup for Master TV (Cont.)

(Continued from previous page)

3.Run Auto Tuning (Channel Search). (continued)

b)Use the Channel Edit option in the Channel Menu to edit the chan- nel lineup, as necessary, to include free to guest channels only.

•Add/delete channels per your system requirements. Note that if Installer Menu item 103 ATSC TUNE MODE is set for Physical Channel tuning (default and recommended setting), channels with minor channel numbers higher than 255 will not transfer correctly in step 4. If it is set for Virtual Channel tuning and either the major or minor channel numbers are higher than 255, the channel(s) will not transfer correctly in step 4.

•Use the Channel Label option in the Channel Menu to add familiar channel trademarks/logos such as ABC, CBS, NBC, etc. to the Channel-Time on-screen display. Identifiable labels (logos) should enable the end user to readily know what common networks are available. (You can add the channel labels in this step, or you can add channel labels or logos for channels without icons in step 5.)

CHANNEL	Move	Enter
Auto Tuning
Manual Tuning
Channel Edit
Channel Label

Run Auto Tuning, edit channels, and select familiar channel trademarks/logos using Channel Menu options.

4.Transfer the TV Setup to the internal TV Controller (PTC):

2-5-5 + MENU Mode

After the TV channel lineup has been edited and channel label icons added, enter the Installer Menu. Once in the Installer Menu, press

2-5-5+ MENU on the Installer Remote to initiate the transfer of the Master TV Setup to the PTC. The TV exits the Installer Menu and then tunes through the channels in the channel lineup during the transfer. When the transfer is complete, the TV tunes back to the channel that was tuned before the transfer began.

Note: The maximum number of active channels that can be transferred is 141. An attempt to transfer more than 141 channels will result in erratic TV tuning operation.

5.Add Custom Channel and Aux Source Labels for Analog Channels: 2-5-4 + MENU Mode

Enter the Installer Menu, and press 2-5-4+ MENU on the Installer Remote. Add/edit custom text labels to channel on-screen displays. Note that digital channels often have a broadcaster generated label (see 2-5-4 + MENU procedural information on page 22). When you are finished, press MENU to exit 2-5-4 + MENU Mode.

6.Verify the TV setup.

At this point, verify that the channel lineup, channel icons, and custom labels are correct. Make sure the TV features are set per your requirements.

7.Lock the channel lineup.

Enter the Installer Menu. Set item 028 CH. OVERIDE to 000 and press ENTER to lock the channel lineup and restrict access to the TV setup menus. Press ENTER again to save your changes and exit the Installer Menu.*

The Master TV Setup is now ready to be copied to a USB memory device or a clone programmer (see cloning information in this document).

DIGITAL 19-3

MONO STEREO SAP

WXYZ

Custom Text Label “WXYZ” created in

2-5-4 + MENU (Add Channel Label) Mode.

028 CH. OVERIDE 000

After verifying the TV Setup, set Installer Menu item 028 CH. OVERIDE to 000.*

*This step prevents end users from accessing channel settings (i.e., the Channel Menu will be inaccessible/ grayed out).

206-4185 13