Cloning Overview / Clonable Menu Features

Cloning Overview / Clonable Menu Features

IMPORTANT CLONING INFORMATION

There are three options for cloning a Master TV Setup:

•Using a USB memory device

•Using a TLL-1100A clone programmer

•Using a LT2002 clone programmer

Each option is described in further detail on the pages that follow. As you perform cloning procedures, be sure to complete each task as indicated. If a procedure or step is omitted or not performed completely, cloning may not work. At each step, pay attention to ensure the TV screen shows the proper message when cloning. If the message indicated does not appear, there is a problem with that step, and cloning may not be successful.

Warning: Copying a blank or incorrect memory into a TV will cause the TV to operate erratically or become inoperable.

Warning: Do not connect a clone programmer to a PPV card installed in the Master or Target TVs, as this will damage the clone programmer and the PPV card.

Before you begin cloning:

•Complete the Commercial Mode Setup for Master TV procedure on pages 12 to 13.

•All equipment should be connected to power and turned ON.

•Both the Master and Target TVs must be in Pass-through Mode.

•Ensure Installer Menu items on Target TVs are set/restored to factory default settings (i.e., set Installer Menu item 117 FACT DEFAULT to 001 on Target TVs) before Teaching is initiated.

•Learning and Teaching is only possible between identical model TVs.

•If using a USB memory device, ensure the USB device has been formatted with FAT format.

•For both Master and Target TVs—If using a clone programmer, ensure the TV signal source is either an Aux or TV (RF) source. If a TV (RF) source, the TV must be tuned to an analog (not a digital) channel.

•LT2002 only—Make sure the batteries in the clone programmer are fresh. If batteries are removed, the clone programmer clock time (if set) will be lost (see page 28 for information on the clone program- mer clock).

•Do not unplug the TV power cord or remove/disconnect the USB memory device/clone programmer while Learning or Teaching, as doing so may cause the TV to malfunction or harm the USB device/ clone programmer, respectively.

Clonable Menu Features

Installer Menu	Audio	Lock
Installer Menu item settings	Auto Volume	Movie Rating
	Clear Voice	TV Rating – Children
Channel	Sound Mode	TV Rating – General
Auto Tuning (Channel Lineup)	Balance	Time
Manual Tuning	TV Speaker	Time
Channel Edit	Option	Auto Clock
Channel Label	Option	Auto Off (Sleep Timer)
	Menu Language
Picture	Audio Language
Aspect Ratio	Caption
Picture Mode	Set ID

Note: Some menu options vary between analog and digital channels and Aux sources.

206-4185