Setup Checklist / Commercial Mode Setup Overview
Setup Checklist
Installation and Setup Checklist __ Unpack TV and all accessories. __ Install batteries in remote control. __ Install TV on VESA mount or stand.
Note: It may be advisable to make all cable connections before installing on VESA mount or stand, as appropriate.
Hardware Connections
__ Install any additional hardware as appropriate to your institution, LAN, etc.
Cable Connections
__ Make all connections to rear jack panel and RF antenna on MPI/PPV card.
__ Make all connections to signal, interactive resources, and Aux sources, as appropriate.
Commercial Mode Setup
__ Complete Commercial Mode Setup (configure all relevant Installer Menu items as required of your institution and configure display features for the end user).
Software Installation
__ Install or configure any software, as applicable, for example, PPV, etc.
Commercial Mode Setup Overview
This document describes how to set up LD330H Pro:Centric™ TVs for Commercial Mode either while in
Pass-through Mode
This mode allows you to configure a Master TV Setup for cloning purposes as well as external VOD/PPV control. Use the Installer Remote to configure Installer Menu items as required for TV operation and set up TV features (Channel, Picture, Audio, etc.). See pages 12 to 13 for detailed information.
FTG Mode
This mode enables Pro:Idiom ® decryption and also allows logical channel mapping of physical channels to remove the need for dash tuning. FTG Configuration Application software is used to configure and/or edit FTG Channel Map and FTG Installer Menu settings. See pages 29 to 37 for information on FTG Mode options and using the FTG Configuration Application.
6 |