FTG Mode of Operation | LG Electronics 32LD330H, 37LD330H manual

FTG Mode of Operation (Cont.)

Creating an FMA Configuration File using the FTG Configuration Application

This section describes how to create an FMA Configuration file that can be saved to a USB memory device. In order to enable Pro:Idiom decryption, it is recommended that you create an FMA Configuration file using the FTG Configuration Application. However, if you do not know the RF channels at the site, there is an option to save (Learn) an FMA Configuration file from a TV (see “Learning an FMA Configuration File from a TV” on page 32).

The procedure below provides an overview of the steps required to create an FMA Configuration (.fma) file. Refer to the Free-To-Guest (FTG) Configuration Application manual for further information. See also FTG Configuration Application sample screens on pages 34 to 37.

Note: FTG Configuration Application software is available online at: www.LGcommercial.com/FTGsoftware.

1.Install (if necessary) and launch the FTG Configuration Application (v5.0.0 or higher) on the PC that will be used to create the FMA Configuration file.

2.Either:

•Open an existing FTG Configuration (.rml) file, if applicable, to use its FTG Channel Map. Otherwise, create a new FTG Channel Map using the FTG Channel Map Editor in the FTG Channel Map Configu- ration Utility. Then, continue with step 3.

Note: Up to 141 logical channels can be defined in the FTG Channel Map.

•To view and/or base a new FMA Configuration file on an existing LD330H FMA Configuration file, click Configure in the FTG Configuration Application menu bar, and select FMA to access the FMA Configuration Utility. Then, click the Open button above the FMA Configuration List, and double-click the desired (.fma) file. A list of the file’s contents will be displayed in the FMA Configuration List window, and you can edit the FMA Configuration List as necessary to create a new file. Proceed to step 4 when you are ready to continue.

3.Click Configure in the FTG Configuration Application menu bar, and select FMA to access the FMA Configuration Utility.

4.To add an FTG Channel Map, click >> under FTG Channel Map to copy the current FTG Channel Map to the FMA Configuration List.

Note: If you make any change(s) in the FTG Channel Map Configuration Utility to the current data to be included in the FMA Configuration List, you will need to recopy the FTG Channel Map to the FMA Configuration List.

5.Load default Installer Menu settings for the LD330H TV:

•Click the down arrow at the right of the Chassis field under Installer Menu Templates, and select 32/37LD330H from the drop-down list of available models.

•Click the Load button.

•Use the FTG Installer Menu Configuration Utility to modify settings, if necessary. Then, return to the FMA Configuration Utility.

•Click >> under FTG Installer Menu Settings to copy the LD330H settings to the FMA Configuration List.

6.Click the Save button above the FMA Configuration List to save its contents to an FMA Configuration (.fma) file for later use.

7.Save the FMA Configuration file to a USB memory device, and proceed to “Teaching FMA Configuration to a TV” on the following page to transfer the FMA Configuration file to an LD330H TV.

206-4185