Cloning Procedures (Cont.)
Learning / Teaching a Master TV Setup using a
Warning: Do not connect a clone programmer to a PPV card installed in the Master or Target TVs, as this will damage the clone programmer and the PPV card.
Cloning is accomplished using the TV/ clone programmer MPI ports for com- munication (see figure).
TLL-1100A Cloning Notes
•Read the IMPORTANT CLONING INFORMATION on page 23 before beginning any cloning procedures.
•Ensure the
•Learning and Teaching is only possible between identical model TVs; however, the
Learn Setup from Master TV
Antenna |
or CATV |
CLONE SELECTION MENU
Selected Bank: CBankX Saved
(1)LEARN FROM TV
(2)TEACH TO TV
(3)SET CLONE CLOCK FROM TV
(4)SET TV CLOCK FROM CLONE
(5)DISPLAY TV SETUP
(6)DISPLAY CLONE SETUP
TLL-1100A Clone
Programmer TV Link | CHARGE |
Loader |
TLL1100A | |
Ready | |
MODE | MENU |
MPI | ENTER |
Cable |
|
RECEIVE | SEND |
1.Ensure the Master TV is set up completely and in
2.If an analog channel is not available, direct tune the TV to an Aux source, or select an Aux source, such as
3.Turn ON the
4.Use the MODE button on the
5.Use the Left/Right arrows on the
6.Plug the other end of the MPI cable into the MPI port on the bottom of the
7.Press 1 on the Installer Remote to select LEARN FROM TV from the Clone Selection Menu. Then, press ENTER to transfer the Master TV Setup into CBankX on the
Learning usually takes about 90 seconds. “LEARNING IN PROGRESS” will be displayed on the screen while the
8.When Learning is complete, disconnect the MPI cable from the Master TV.
CLONE SELECTION MENU Selected Bank: CBankX Saved
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
THE CLONE IS VERSION VX.X.X
-To change menu items, press channel keys or digits.
-To execute item, press Enter.
25 |