LG Electronics 37LD330H, 32LD330H setup guide Power Cord, Overloading, Grounding, Disconnect Device

Page 3

IMPORTANT SAFETY INSTRUCTIONS

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with dry cloth.

7.Do not block any ventilation openings. Install in accor- dance with the manufacturer’s instructions.

8.Do not install near any heat sources, such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where it exits from the apparatus.

11.Only use attachments/accessories specified by the manufacturer.

12.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/ apparatus combination in order to avoid injury from tip- over.

PORTABLE CART WARNING

13.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been dam- aged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

14.Never touch this apparatus or antenna during a thunder or lighting storm.

15.When mounting a TV on the wall, make sure not to install the TV by the hanging power and signal cables on the back of the TV.

16.Do not allow an impact shock or any objects to fall into the product, and do not drop objects onto the screen.

17.Power Cord

Caution: It is recommended that appliances be placed upon a dedicated circuit; that is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of the Owner’s Manual to be certain.

Periodically examine the cord of your appliance, and if its appearance indicates damage or deterioration, unplug it, discontinue use of the appliance, and have the cord replaced with an exact replacement part by an authorized servicer. Protect the power cord from physical or mechanical abuse, such as twisting, kinking, or pinching or being closed in a door or walked upon. Pay particular attention to plugs, wall outlets, and the point where the cord exits the appliance.

Do not use a damaged or loose power cord. Be sure to grasp the plug when unplugging the power cord. Do not pull on the power cord to unplug the TV.

18.Overloading

Do not connect too many appliances to the same AC power outlet as this could result in fire or electric shock. Do not overload wall outlets. Overloaded wall outlets, loose or dam- aged wall outlets, extension cords, frayed power cords, or damaged or cracked wire insulation are dangerous. Any of these conditions could result in fire or electric shock.

19.Outdoor Use/Wet Location

Warning: To reduce the risk of fire or electrical shock, do not expose this product to rain, moisture or other liquids.

Do not touch the TV with wet hands. Do not install this prod- uct near flammable objects, such as gasoline or candles, or expose the TV to direct air conditioning.

Do not expose to dripping or splashing and do not place objects filled with liquids, such as vases, cups, etc., on or over the apparatus (e.g., on shelves above the unit).

20.Grounding

Ensure that you connect the earth ground wire to prevent possible electric shock (i.e., a TV with a three-prong ground- ed AC plug must be connected to a three-prong grounded AC outlet). If grounding methods are not possible, have a qualified electrician install a separate circuit breaker. Do not try to ground the unit by connecting it to telephone wires, lightening rods, or gas pipes.

21.Disconnect Device

The mains plug is the disconnecting device. The plug must remain readily operable.

As long as this unit is connected to the AC wall outlet, it is not disconnected from the AC power source even if the unit is turned Off.

(Continued on next page)

206-4185

3

Image 3
Contents Copyright 2011, LG Electronics U.S.A., Inc 206-4185 Rev aFor Customer Support/Service, please call­ Disconnect Device Power CordOverloading GroundingTransporting Product CleaningOutdoor Antenna Grounding Antenna Grounding According to NEC, ANSI/NFPATable of Contents Setup Checklist / Commercial Mode Setup Overview Setup ChecklistCommercial Mode Setup Overview Help ProCentric TV Interactive Menu FeaturesChannel Guide InformationMPI LD330H Rear Jack PanelComponent AUDIO/VIDEO2 Input Side Connections Panel / RF Antenna ConnectionSide Connections Panel RF Antenna ConnectionCloning Installer OverviewInstaller Remote Installing Batteries in Installer RemoteInstaller Remote Control Typical Key Functions VOLMenu Run Auto Tuning Channel Search Commercial Mode Setup for Master TVSet Installer Menu items Set up TV featuresLock the channel lineup Verify the TV setupExiting the Installer Menu and Activating Updates Installer MenuAccessing the Installer Menu Using the Installer MenuBrief Description of Function and Comments Installer Menu Items 000 throughCH not Avble Installer Menu Items 073 throughDetailed Descriptions of Installer Menu Items Installer SequenceMute Disable Poll Rate Sleep TimerFeature Level Caption LockRear RGB EN. Rear RGB Enable DIS. CH-TIME Disable Channel-TimeEN. CH-T COL. Enable Channel-Time Custom Color Chksm Error Checksum ErrorAtsc Band Atsc Tune ModeProcentric Back LightingTV Setup Menus Overview To perform channel editing/labeling Editing/Adding Channel Icons and/or LabelsCloning Overview / Clonable Menu Features Clonable Menu FeaturesBefore you begin cloning USB Cloning Notes Cloning ProceduresLearn Setup from Master TV Teach Master TV Setup to Target TVTLL-1100A Cloning Notes TLL-1100A Clone Programmer TV LinkCable Optional Set the Clock LT2002 Cloning Notes Different Master TV SetupsFrom previous TV Setup Menus FTG Mode of OperationFTG Mode Overview Determining the TV Operating ModeFTG Mode of Operation Teaching FMA Configuration to a TV Learning an FMA Configuration File from a TV Optional Manual Configuration / Setup for a TV Print MAP FTG Configuration Application Utilities OverviewFTG Channel Map Configuration Utility EDIT/ADD MAPADD UpdateFTG Channel Map Editor DeleteFTG Installer Menu Configuration Utility Installer DefaultsHOSPITAL-GRADE TV only FMA Configuration Utility FMA Configuration ListNEW/OPEN/SAVE Upgrading TV/PTC Software Checking the Software VersionsDownloading a Splash Screen Image Splash Screen Image File GuidelinesStatic Reference Power Consumption SettingsCamport Operation FTG or PPV Reference TV Camport Auto Sense OperationCamport Side Video Functionality Control Camport Operation Stand-aloneEnable Reference TV Aux Input ConfigurationReference Resetting a TV to Pass-through Mode General Troubleshooting TroubleshootingController Quick Check Troubleshooting Flow ChartCommercial Mode Check / FTG Operation Troubleshooting FTG Operation TroubleshootingSymptom Possible Causes Solutions Clone Programmer Clone Programmer TroubleshootingReset Clone Programmer After Static Shock Symptom Possible Causes Possible SolutionsGlossary of Terms Document Revision History / Notes Document Revision HistoryDate Description May Revision a New document For Customer Support/Service, please call­
Related manuals
Manual 267 pages 53.59 Kb