Firstech, LLC CM4200, CM3 SERIES, CM1000A manual CM-3000 Wiring Detail

CM-3000 WIRING DETAIL

CONNECTOR 1

Pin 1 Red- Constant 12-volt (+) positive power input for the control module. This wire must be connected to a constant 12-volt (+) positive source. The proper wire will test 12-volt (+) positive with the key in the off position, while key is in the on position and during crank.

Pin 2 Green/White- Parking light (+) positive output. Connect this wire to the (+) positive parking light wire generally at the parking light switch or behind the fuse box. The proper wire will test 12-volts (+) positive when the parking light switch is in the on position.

Pin 3 Red/White- Constant 12-volt (+) positive power input for the starter and accessory on-board relays. This wire must be connected to a constant 12-volt (+) positive source. The proper wire will test 12-volts (+) positive with the key in the off position, while the key is in the on position and during crank

Pin 4 White- Accessory 12-volts (+) positive output. This wire must be connected to the heater and A/C blower motor wire. The proper wire will test 0-volts with the key in the off position, 12-volts (+) positive while key is in the on position, 0-volts while cranking and back to 12-volts (+) positive with the key in the on position

.

Pin 5 Violet- 250mA (-) negative output when armed and remote started. This wire will provide a (-) negative output when system is locked and armed and during remote start for anti-grind. (Note: This wire can also be used to trigger after-market L.E.D. kits and other after-market accessories. Output must be diode isolated when used to trigger after-market accessories.)

Pin 6 Yellow- Starter 12-volt (+) positive output. This is pre-wired to pin 87a of the starter interrupt relay. This wire will provide12-volts (+) positive to the vehicles starter. The proper wire will test 0-volts with the key in the off position, 0-volts while the key is in the on position and 12-volts (+) positive during crank. (Note: The vehicle starter wire will need to be cut. The yellow wire from pin 87a on the starter interrupt relay will go to the starter side of the vehicles starter wire. The yellow/black wire from pin 30 of the starter interrupt relay will go to the key side of the vehicles starter wire.)

Pin 7 Green and Red –Ignition output and input. This wire must be connected to the vehicles ignition to power up all accessories and to trigger remote programming. The proper wire will test 0-volts with the key in the off position, 12-volts (+) positive while the key is in the on position and 12-volts (+) positive during crank. (Note: Red wire is the ignition input for the pre-wired starter kill relay.)

- 20 -